资源列表
led_flash
- 用软件CCS3.1编写的一个DSP程序，功能是让输出灯闪烁。-Software written in a DSP program CCS3.1, function is to allow the output light flashes.
dsp
- Pwm输出信号的设计 试设计四路（PWM1,PWM2,PWM3,PWM4）输出，载波频率为8ms，波形关系如图所示（一个周期）： -Design test design four (PWM1, PWM2, PWM3, PWM4) output Pwm output signal carrier frequency of 8ms, waveform relationship shown in Figure (a period):
41 射击训练游戏
- 基于单片机的射击训练游戏，全套包括hex和电路图(Microcontroller based shooting training game, a full set, including hex and circuit diagram)
I2SBUS
- I2S bus specification
9时钟显示
- zigbee cc2530 基础实验之九 时钟显示编程实验(ZigBee CC2530 basic experiment nine clock display programming experiment)
实验9 PWM输出实验
- STM32的PWM输出程序，亲测可用。内有详细注释和说明文档，很好的参考资料。(STM32 PWM output program, pro-test available. There are detailed notes and documentation, good references.)
NRF24L01一对一接收模块
- 基于51单片机的2.4G收发程序，里面包含工程文件。(2.4G transceiver based on 51 single chip microcomputer, which contains engineering documents.)
基于51单片机循迹、红外避障、遥控综合程序
- 智能小车在基于51单片机上能够实现循迹、红外避障、遥控综合、PWM调速的功能。(The smart car in the 51 SCM to achieve the tracking, infrared obstacle avoidance, remote control, speed control function based on PWM synthesis.)
Task2
- should upload 5 codes/
DS1302时钟LCD1602显示（可以按键设置时钟）
- DS1302时钟LCD1602显示（可以按键设置时钟）(DS1302 clock LCD1602 display (key setting clock))
传感器51测试程序
- 这个是光敏二极管的的C51程序，我也不知道怎么样，还要调(This is the C51 program of photosensitive diode. I don't know how to adjust it.)
Proteus程序1
- 使用Proteus程序，P1口做输入口，接八个开关，以74LS273做输出口编写程序读取开关状态，在发光二极管上显示出来。(Using the Proteus program, the P1 port is the input port, and then eight switches are connected. The program reads the switch state with the 74LS273 as the output port and displays it on t