资源列表
ds12c877a
- 实时时钟芯片的读写控制，用AT89S52调试通过。端口均说明，可以放心使用。-Read and write real-time clock chip control, through the use AT89S52 debugging. Ports are that they could feel free to use.
PT2262
- 该程序为用ATmega16实现PT2262持续输出信号波形的程序，可以读地址读数据并发送-ATmega16 using the program to achieve sustained output signal waveform PT2262 procedures, reading the address data can be read and send
NONAME1
- 51单片机实现数字时钟带闹钟 使用6个弹跳按钳和4个共阴七段显示器组合而成-51 MCU digital clock with alarm
ADC0832_Program
- 用51单片机完成对ADC0832的控制。其中ADC0832是一款8位串行AD转换芯片。-MCU with 51 to complete the ADC0832 control. One ADC0832 is an 8-bit serial AD converter chips.
main
- 实时时钟PCF8563的源程序，用C语言写的，可以在C51下用的-Real-Time Clock PCF8563 the source code, written using C language, can be used under C51
sf
- 通过单片机控制和时钟芯片，实现秒，分，时的时钟设计-Through the MCU and clock chip, to achieve seconds, minutes, hours, clock design
lcd1602
- 89c52+lcd1602的测试程序，在实验板上测试过可以用-89c52+ lcd1602 testing procedures, the board tested in the experiment can be
74HC95-driven-digital-display
- 本程序代码为用74HC95来驱动数码管显示， 硬件环境:CA-M8X 打开的开关如下 S6(1,2,5,6,7) - 外部4MHz晶振和595接口 J8(EN-SEG) - 数码管显示允许-This procedure for the use of 74HC95 code to drive the digital display, hardware environment: CA-M8X switch to open the following S6 (1,2,5,6,7)-
PIC_spi
- PIC单片机通过SPI接口与数码管控制芯片PT6961芯片通信-PIC microcontroller through SPI interface and digital tube control chip PT6961 chip communications
LCD1602
- lcd1602液晶显示驱动 主要用于51系列单片机-lcd1602 displaydrive this code very good
main
- 飞思卡尔单片机程序，实现一个秒表功能，然后归零-Freescale microcontroller program, and a stopwatch function, and then zero
lesson6
- DS18B20驱动显示程序，应用于PIC开发板-DS18B20 drive display program, applied to the PIC development board