资源列表
testmain
- vxWorks下可用的串口测试程序，初学者易用-vxWorks serial testing procedures available under
2
- 东软嵌入式高级C培训(2007))，看了就知道了，很多提高程序效率的方法，和调试的技巧都很经典实用。-Neusoft Senior C Embedded Training (2007)), read to know, a lot of ways to improve program efficiency, and debugging skills are very classic and practical.
ATmega16-generate-sine-wave-source
- ATmega16 产生正弦波 源程序-ATmega16 generate sine wave source
timer
- 在使用12MHz晶振的条件下，由8051内部定时器1按方式1工作，即作为16位定时器使用，每0.05秒钟T1溢出中断一次。P1口的P1.0～P1.7分别接发光二极管的L1～L8。（用连线连接J2、J3）。 要求：编写程序模拟一循环彩灯。彩灯变化花样为：①L1、L2、…L8依次点亮；②L1、L2、…L8依次熄灭；③L1、L2、…L8全亮、全灭。各时序间隔为0.5秒。让发光二极管按以上规律循环显示下去。 编写一个救护车警笛声程序，要求：高低两种音调交替出现，交替周期1～1.5S。-Condi
jieshou
- 单片机双击通信接收代码，将传送过来的数字显示在七段数码管上，并且实时将主机发过来的数字如温度显示出来-SCM double-communications receiver code will be sent over the digital display on the 7-segment digital tube, and real-time host sent me digital temperature display
NTC_TEMP
- 对NTC电阻进行查表测温，并对两点之间的温度进行平均运算。是学习电阻测温最好的C程序。-NTC resistor for temperature measurement on the look-up table, and the average temperature of between two operations. Resistance temperature is to learn the best C program.
main
- 主程序等待外部中断触发的噪声报警，LED显示运行状态-Main program wait for an external interrupt trigger noise alarm, LED display operating status
Text1
- 给遥控解码，在十米之内，只要有红外线感应，就能读出码.-To the remote control decoder, within the ten meters, as long as there are infrared sensors, knows the code.
dac8501
- 采用MSP430作为控制器，通过SPI接口控制16位串行DAC-adc8501,输出相应电压-Using MSP430 as the controller through the SPI interface control 16 serial DAC-adc8501, the corresponding output voltage
B20beiyong
- 18B20.可移植的标准模板程序，用于51系列单片机-18B20. Portable standard template program for 51 series
IIC_AT24C02
- 写入数据到存储器中，再从其中读取数据，并送到指定端口中。 -Write data into memory, and then reads the data from, and sent to a specific port.
DSP28_Adc
- 对2812的AD模块进行初始化,运行于启动/停止模式,级联方式-2812 AD module to initialize, run in start/stop mode, cascade mode