资源列表
KEY-AND-LED-DISPLAY
- 本程序是检测矩阵键盘，并且用数码管显示键值的。经过反复的测试证明程序稳定，可靠。
34
- 利用单片机和两个按键控制步进电机智能正反转-The use of microcontroller and two buttons control the stepper motor Intelligent positive inversion
UART0
- 此程序是单片机C8051F020的UART0串口调试程序，经验证成功。-This program is the UART0 C8051F020 microcontroller serial debugger, proven successful.
traffic
- 交通灯的程序，是使用AT89C51单片机做的-Traffic light procedure is done using AT89C51 microcontroller
daobao
- 基于PCL-812PG采集卡的开关量通道，实现模拟流水线打包机工作过程的c代码。-PCL-812PG acquisition card based on the digital channel for analog line packer working process of the c code
zuoye3_1
- 四位LED显示程序，将一定单元的数值送到LED显示，包括延时-Four LED display program, the value will be sent to the LED display unit, including the delay
C
- 32位单片机通过I/O端口实现流水灯显示的程序-Water light display program 32 microcontroller I/O ports
jiaotongdengdekongzhichuxue
- 这是通过定时器中断来控制三种颜色灯的亮灭，它有两种模式，可以由键盘控制模式的转换-This is the timer interrupt to control the three colors of light, light off, it has two modes, the conversion from the keyboard control mode
lianggehanzijingzhi
- led点阵的静止显示。通过8个8X8的led点阵模块实现两个汉字的显示。-Static LED dot matrix display. Through the LED dot matrix module 8 8X8 display two Chinese characters.
flashdriver
- msp430g2553 launchpad flash 驱动 可在掉电前保存一些重要数据 已在launchpad上面验证过-msp430g2553 launchpad flash driver by using functions in the driver you can save some important data in flash before power off
main
- 基于MSP430的LED实现,控制8个LED闪烁，用于测试下载功能是否正常-MSP430-based LED implementation, control 8 LED flashes used to test whether the download function properly
wt588d_f149
- 基于MSP430X14X系列单片机的已封装好的基于wt588d语音模块程序。-MSP430X14X based microcontroller series based on the encapsulated wt588d voice module procedures.