资源列表
AD
- 本实验的波形发生模块提供1V 50Hz正弦波、0.5V 350Hz正弦波、和前两种波形的叠加波。-The waveform in this experiment took place module provides 1V 50Hz sine wave, 0.5V 350Hz sine wave, and the first two waveforms were stacked kapa.
PWM
- 由DSP的外部输出给出控制直流电机的L293D正向和反向控制信号，然后由L293D驱动后来控制直流电机的运转。-External output is given by the DSP-controlled DC motor L293D forward and reverse control signal, and then later by the L293D-driven control of DC motor operation.
AT91SAM7X256
- AT91SAM7X256的开发程序，主要应用与CAN转USB中
99273896GIVEIO
- givo驱动，嵌入式开发必不可少的一个驱动软件。-givo driver,it is embed nessary s driver.
dspic6010threephasepermanentmagnetsynchronousservo
- micro chip公司dspic 6010三相永磁同步伺服电动机磁场定向速度控制程序-micro chip company dspic 6010 three-phase permanent magnet synchronous servo motor speed field-oriented control procedures
F280xDCMOTORSpeedPositionControlofBrushedDCMotorUs
- F280x中使用qep对直流电机速度位置控制-F280x DCMOTOR Speed & Position Control of Brushed DC Motor Using QEP Without Index
MCX314
- 基于AVR的mcx3144轴控制器的系统开发，为开发提供的文献参考-AVR-based mcx3144 axis controller system development, to provide for the development of literature references
SensoredFieldOrientedControlof3phasePMSMUsingQEP.r
- 永磁同步电机使用QEP进行传感器磁场位置定向控制程序-SensoredFieldOrientedControlof3phasePMSMUsingQEP
USART1_USART2_arm-none-eabi-gcc
- USART1 & USART2 communication example using arm-none-eabi-gcc compiler by codesourcery.
SensoredPositionControofPMSMUsingQEP
- 永磁同步电机的位置控制，使用光电编码器位置传感器-Sensored Position Control of PMSM Using QEP
XKK2
- 一个关于AT91SAM7SE的工程例子，部分代码为本人所写，主要为一个键盘处理的程序，程序需要在Keil下编译-A project on the AT91SAM7SE example, some code I wrote, mainly a keyboard handling procedures, the program needs to compile under Keil
VxWorksWebServer
- 嵌入式操作系统VXworks在webserver中的应用，很好的一篇文章。-Embedded operating system VXworks the webserver application, a very good article.