资源列表
TA
- msp449的关于定时器TA的C语言程序-msp449 timer TA on the C language program
74hc165
- 本例子是用硬件SPI接口循环发送一个变量到74HC595，并且在数据发送完毕后通过单片机的另外一个IO接口PB2输出一个“锁存”脉冲 ，使74HC595把移位寄存器的数据输出到锁存寄存器,并驱动8个LED输出，实现来回流水的效果。-This example is using the hardware SPI interface to send a variable to the loop 74HC595, and after the data is sent through the microc
usartPrintf
- STM32单片机串口打印，可直接调用Printf,scanf函数-STM32 microcontroller serial printing, you can directly call Printf, scanf function
LED_FLASH_449
- 关于msp449的发光二极管的闪烁程序代码-About msp449 flashing LED code
sp_449
- 关于MSP449的发声演示程序C语言代码-The voice on the MSP449 C language code demo program
LTN101NT06-001
- LTN101NT06-001液晶屏，支持1024*600分辨率，LVDS驱动，大小尺寸为10.1，大视角-LTN101NT06-001，is a color active matrix TFT (Thin Film Transistor)liquid crystal display(LCD)that uses amorphous silicon
freeRTOSPLWip
- freeRTOS和LWIP协议栈在STM32处理器上的移植，非常具有参考价值-freeRTOS and LWIP stack migration in the STM32 processors, very valuable
Instrument_Control_VISA
- 在VB平台上通过VISA协议控制仪器仪表的演示程序，以控制频谱分析仪为例。-Demo VB programe to control instruments, eg. Spectrum Analyzer, with VISA protocol.
ADC
- 实现STM32 ADC转换，源代码从ADC配置，到处理，好用。-Achieve STM32 ADC conversion, the source code from the ADC configured to handle, easy to use.
motor
- 主要功能是计算步进电机每圈的脉冲数和每个脉冲相隔的时间，实现对步进电机的控制-Main function is to calculate the stepper motor the number of pulses per revolution and the time gap between each pulse, to achieve control of the stepper motor
LCL-SPWM-winder
- 风力发电用LCL滤波SPWM并网逆变电源的研究 采用直接馈网电流有效值作为外环，桥臂输出电流瞬时值作为内环的双闭环控制策略，既保证了 系统的稳定性，又提高了并网电流的直接控制精度。-zan wu
Four-Edge-detection
- 四种不同的图像边缘检测代码，是基于DSP的。可帮助大家学习DSP应用系统的设计与开发。检测效果很好-Four different edge detection code can help you learn DSP application system design and development. Detection works well