资源列表
sms1613_c51
- 太阳人液晶屏sms1613的演示程式，C51编写。-Sunman LCD sms1613 demonstration program, C51 write.
SCM-232-serial-communication-program
- 单片机 232 串口通讯程序，用于串口通讯设计-SCM 232 serial communication program
RCServo.v
- Generate RC SERVO PWM Verilog
PIDcontrol
- PID control 各种应用，包括飞思卡尔小车上pid调节-pid control all sort of applications include pid control for robot car
temp
- 课程设计 测频程序 线性插值测温度5度标定 我得单片机课程设计 做了两天的 用555定时器和51单片机的测频程序组成的景区温度测量电路 用线性插值的方法测量 很准的 10k的NTC电阻 1602显示-Frequency measurement program curriculum design temperature of 5 degrees linear interpolation of measured single-chip calibration I have to do a two-d
Glitch-sensitive-dedicated-board
- ATMEL16上开发，当产品电压在800us内电压高与13.2与低于11.3V时，就会输出一个两分钟的高电平信号，两分钟之内同时一个LED灯亮，另外一个LED灯也一直亮，直到按键被按下时，该LED才关闭。等到下一个失灵电压到来时，该功能再一次被触发。-ATMEL16 on the development, when the product of voltage high voltage 800us and 13.2 and lower than 11.3V, it will output a h
project6.1
- AVR Atmega16 4MHz LCD USART
temperature-PID-controller-
- 基于STM32的温度控制器系统设计，带液晶显示，带死区控制，在实验室实验，效果较好。-temperature controller
STM32--LED
- STM32开发板例程LED- STM32开发板例程LED--STM32 development board the routine 1
sd
- SD卡的全驱动源程序，51读写SD卡源码-SD card full driver source code, read and write SD card source code 51
STM32-ADC
- 基于STM32-cortex3 开发板应用实例工程文件-模数转换实验-Development board based STM32-cortex3 Applications project files- analog-digital conversion experiments
gpio-iic
- 基于cc2530，利用iic控制灯闪烁，基于IAR-Based on cc2530, use iic control lights flashing, on IAR