资源列表
keyboardP-
- 单个独立按键控制led输出状态 按下加按键，数值增加直到最大值，按减按键，数值减小，直到最小值-Independent control of a single button press the plus button led output state, the value increased until the maximum, according to cut key, value decreases until the minimum
C8051F34x-DK
- C8051F34X 系列开发工具指南 适应于刚开始接触C8051单片机开发者 -C8051F34X Series Development Tools Guide to adapt to the beginning of exposure to C8051 MCU developers
1602Dynamic-display
- 名称：LCD1602 内容：通过标准程序动态显示字符 引脚定义如下：1-VSS 2-VDD 3-V0 4-RS 5-R/W 6-E 7-14 DB0-DB7 15-BLA 16-BLK-Name: LCD1602 content: The standard procedure for dynamic display of character pins are defined as follows :1-VSS 2-VDD 3-V0 4-RS 5-R/W 6-E 7-14 DB0
C8051F040_drive_L298
- c8051f040单片机通过控制L298驱动两相四线步进电机程序-c8051f040 L298 driver chip by controlling the two-phase four-wire stepper motor program
bas
- 循迹小车源代码——此代码为智能小车的循迹程序，智能小车课寻黑线，在黑线的引导下前进-Car tracking source code- the code for the smart car tracking program, the smart car class to find the black line, black line under the guidance of the forward
miaobiao
- 用动态扫描方法和定时器1在数码管的前三位显示出秒表， 精确到1 秒，即最后一位显示1 秒，一直循环下去 设时钟频率为12M-With dynamic scanning method and Timer 1 in the top three shows digital stopwatch, accurate to 1 of the second and final one shows 1 seconds, the clock has been set down cycle freque
liushuideng-saomiao
- 利用动态扫描和定时器1在数码管上显示 出从765432开始以1/10秒的速度往下递减 直至765398并保持显示此数，与此同时利 用定时器0以500MS速度进行流水灯从上至 下移动，当数码管上数减到停止时，实验 板上流水灯也停止然后全部开始闪烁，3秒 后（用T0定时）流水灯全部关闭、数码管上 显示出"HELLO"。到此保持住。 设晶振频率为12MHz。-The use of dynamic scanning and Timer 1 in the digital d
voltmeter
- 电压值的十进制显示，即电压表,精度为两位小数-Voltage value of the decimal show the voltmeter with an accuracy of two decimal places
lt-mini-m16-test
- lt-mini-m16 avr单片机整版测试的程序-lt-mini-m16 avr microcontroller full-page test procedures
snake
- 51单片机写的吞食蛇游戏，基于128*64的LCD-51 MCU written swallowed snake game, based on the LCD 128* 64
menu
- 51单片机写的结构体式简易菜单,可通过protus进行仿真-51 MUC write simple menu structure
PIC_Graphics-
- PIC_Graphics pc模拟-PIC_Graphics pc simulation