资源列表
frequency_timerA
- 基于timerA，采用计数法完成数字信号频率测量，使用片内时钟DCO时钟频率为默认值，获得金近似1s的时间闸门，即调整delay循环次数实现-Based on timerA, USES the count method is used to complete the digital signal frequency measurements, use the clock DCO within the clock frequency for default, obtain approximate
key_3
- 基于p/o口中断的3位按键输入多个数据，使用p1.0，p1.1，p1.2管脚输入按键信号，通过模拟同步串口控制3个7段共阴极数码管-Based on the p/o mouth interrupted the three key input more data, use p1.0, p1.1, p1.2 tube feet enter key signal, through the simulation synchronous serial control three of seven sect
SourceCode04_SPILED1
- 代码05-12C数码管显示实验源程序代码-Code 05-12C digital tube display experiment source code
arm920t-eabi-4.1.2
- 编译yaff2文件系统的工具，俗称瑞士军刀，比较好用的版本。-Tools compile yaff2 file system
jffs2
- yaff2文件系统详细说明，嵌入式linux设计比较好的资料，对编译文件系统很有用-yaff2 file system in detail the design of embedded linux better information is useful to compile the file system
VIVIcompile-and-configure-
- vivi的编译和配置详细说明，对编写bootloader非常有用。-vivi compile and configure the detailed instructions, very useful to write bootloader.
YB0F2
- 经过红外接收头解调后单片机接收到的高低电平是和遥控器发射时是相反的一个过程 * 兼容 1T-12T单片机中断方式红外接收数据，并通过串口发送 程序编辑： lbq691477940 22/07/20-The MCU receives the infrared receiver demodulation to low launch and remote control is the opposite of a process* Compatible 1T-12T microcontrolle
gps-ins-dsp
- Inertial navigation system implementation in c and tested on a powerful DSP platform, it s simple and easy to read
LPC2124-Proteus-temptruer-
- LPC2124的温度模糊控制系统Proteus仿真 + 源代码。电路图 程序 -The LPC2124 temperature fuzzy control system of Proteus simulation the+ source code. Schematic procedure
seg7_3
- 通过模拟同步串口控制 3 个 7 段共阴极数码管，使用片内时钟，时钟频率为默认值 -Through the simulation synchronous serial control three of seven sections of the cathode digital pipe, use the clock in, the clock frequency for default
clock
- 数字钟，采用电平触发，可以切换显示模式。-Digital clock, trigger level, you can switch the display mode.
16021602
- 温度测量18B20+1602显示,已经调试，可以很好的使用-Temperature measurement 18B20+1602 display