资源列表
shuiwen1
- 利用单片机对水的温度进行控制，同时随时可以根据继电器和电风扇对水温改变。-Microcontroller to control the temperature of the water, ready to water temperature change according to the relay and the fans.
GCC-AVRgezhongzichengxu
- GCCAVR各种子程序，配有仿真图，并在PCB上验证，MCU上各种资源都有程序，如定时器，LCD1602等-GCCAVR a variety of subroutines, with a simulation and verified on the PCB, various resources have on the MCU, such as timers, LCD1602, etc.
ARM10tempture
- ARM10温湿度传感器sht10应用代码，内含驱动及测试程序-The the ARM10 temperature and humidity sensor sht10 application code contains drivers and test procedures
wire-control--program
- 无线遥控 程序详尽 绝对超值 -wire control program. very detail
ps2verilog
- 基于FPGA开发环境下的PS2实现入门源代码-Getting Started with source code based FPGA development environment under the PS2
verilogsram
- 基于FPGA开发环境下设计的静态随机存储器-Static random access memory based FPGA development environment designed
de_dect
- LIFT CONTR0LLER...DESIGNED WITH FINITE STATE MACHINE WITH MOORE MACHINE
UART_verilog
- 电脑发数据，CPLD接收后会送电脑的，verilog程序，可以直接使用-Computer to send data, the CPLD will be sent after receiving the computer, Verilog program can be used directly
PXA270-datasheet
- pxa270 datasheet ,ArmLinux 嵌入式开发基础-pxa270 datasheet, ArmLinux embedded development foundation
zigbee_networkAddress
- 本程序用于计算包括协调器在内的五层zigbee网络拓扑结构，输出格式为父节点网络地址/本节点网络地址/本节点类型。通过查询输出文件，可以根据节点网络地址查询zigbee网络拓扑。-This procedure is used to calculate the five-story zigbee network topology, including the coordinator, the network address of the parent node of the output form
shuzixitongn
- VHDL代码 计数器 完成一分钟内的计数，到59清零，提供4个频率选择-VHDL code counter finished within one minute count to 59 cleared, 4 frequency selection
232-can
- 本程序是用于RS232串口转CAN，CAN转RS232串口的数据通信程序，使用一个51单片机做中转控制器。-This procedure is used for RS232 serial to CAN, CAN turn the RS232 serial data communications program, using a 51 microcontroller to do the transfer controller.