资源列表
xianshi
- 基于单片机的GPS测控技术，完整的C程序源代码，-Microcontroller-based GPS measurement and control technology, the complete C source code.
ADCDriver
- WCE5.0系统的ADC驱动，mini2440，已在PB上编译成功-ADC Driver of WCE5.0 system mini2440, has been compiled in PB success
STM32F103timer-gpio
- 定时器定时中断，点亮GPIO连接的发光二极管。-The timer interrupt, light GPIO connected light-emitting diodes.
51_12864
- LCD12864液晶并行驱动程序，含纯数字和汉字程序-LCD12864 LCD parallel drivers with pure numbers and characters procedures
PWM
- 外部电位器调节PWM的占空比，根据电位器采样值来改变占空比-Potentiometer adjust the duty cycle
VERY-USEFUL
- 单片机数字电压表，可以用PROTEUS软件打开，电路图已经设计好。-VERY USEFUL
DPM21A
- ＳＴＣ单片机采样并计算交流电流，在ｌＥＤ上显示出来-STC SCM sampling and calculation of alternating current, displayed on lED
DPM21C
- ＳＴＣ单片机采样并计算单相交流功率因数，可以自动校正-STC SCM sample and calculate the single-phase AC power factor, and can automatically correct
DPM21P_
- ｓｔｃ１２Ｃ５Ａ１６Ｓ２采样并计算有功功率，用按键操作自动校正-stc12C5A16S2 sampling and calculation of active power, the key operation is automatic correction
DPM23A
- ｓｔｃ１２Ｃ５Ａ１６Ｓ２采样并计算三相电流，用按键操作自动校正-stc12C5A16S2 sampling and calculation of three-phase current key operation, automatic correction
DPM23V
- ｓｔｃ１２Ｃ５Ａ１６Ｓ２采样并计算三相电压，用按键操作自动校正，ＬＥＤ显示-sample and calculate the three-phase voltage stc12C5A16S2 button automatic calibration operation, LED display
EDA
- 其测量范围为1MHz。量程分10kHz，100kHz和 1MHz三档（最大读数分别为9.99kHz,99.9kHz,999kHz）。 被测信号由信号发生器提供。 -The measuring range of 1MHz. Range sub-10kHz, 100kHz and 1MHz third gear (maximum reading for the 9.99kHz, 99.9kHz, 999kHz). The measured signal from the signal generat