资源列表
verification-of-SLM-and-RTL
- VERIFICATION OF SLM AND RTL
MD1
- 51与MD204L通信程序，已测试，可用-51 MD204L communication procedures have been tested, can be used
CANAPP
- LPC23XX系列CAN滤波器配置。单个标准帧，单个扩展帧，单个标准帧组，单个扩展帧组例程。-LPC23XX series CAN filter configuration. A single standard frame, a single extended frame, a single standard frame group, a single extended frame group routines.
Graduation-design_1
- 小弟曾经的毕业设计 《电子时钟》时钟芯片DS1302 液晶1602显示 贴出来和大家交流下 请各位多多指点-The younger brother had graduated from design electronic clock posted and please a lot of advice
mapper
- 个人编写的wimax协议的映射部分程序，可以实现ask、bpsk、16qam和64qam四种调制功能，使用查表的方式实验，程序简单易懂！-Wimax protocol mapping part of the program was written by individuals, you can ask, BPSK, 16qam and 64qam four kinds of modulation functions, the use of look-up table way of experim
demapper
- wimax协议的解映射部分的实验，可以实现ask、bpsk、16qam、64qam四种调制方式，用查表的方式实现！-wimax protocol demapping part of the experiment can ask, BPSK, 16qam, 64qam four kinds of modulation, using a look-up table!
RISC_CPU
- 关于risc cpu 的pdf 希望对学习Risc cpu的人有用-Hope that the study of Risc cpu risc cpu pdf
UART
- TI MSP430低功耗单片机 串口通信程序-TI' s MSP430 low-power single-chip serial communication program
TimerA3
- TI 低功耗MSP430单片机定时器例程 T1，T2，T3，T4定时器的全部例程-All routines of TI' s low power MSP430 microcontroller timer routine of T1, T2, T3, T4, and the timer
motor
- AGV电机调速的程序 实现了电机速度的控制，首先由USB控制器（Propo）向上位机发出信号，上位机将控制器的数字指令转变为0-3000rpm的转速目标值。通过串口转发给arm单片机，ARM单片机接收上位机的目标值及电机反馈回来的转数，利用PID控制器计算出0-1023的控制指令，传给D/A转换器，它将数字信号转换为0～5V的模拟信号，模拟信号经过电源隔离模块后传送到驱动模块对电机进行调速。此外，电机再将脉冲信号返回给微处理器。-Procedures of the AGV motor speed
IO_UART
- keil软件下开发单片机IO口模拟uart与LTK4101通信-mcu communication with ic by io
fft-(2)
- 实现fft的源程序 ，c语言实现，非调用，源程序-Fft source code, c language, non-call, the source