资源列表
HT32F1253_CoOS
- 设备: Holtek HT32F1755 评估板: HT32F175x_275x Development Board 集成环境: CoIDE V1.4.2 Tasks: task_init 初始化所有的硬件，创建所有的事件标志和互斥体。 taskA 闪烁LED2和LED3。 taskB 通过USART输出ADC转换的数值 taskC 用RTC显示时间，通过USART输出 描述： 系统启动时，LED2和LED3闪烁，时间在超级
rc_Release
- 单片机 接收红外然后转无线程序 无线用nrf24c01 -Microcontroller to receive wireless infrared and then turn the wireless program with nrf24c01
AT91SAM3U4E-CoBuilder0.7
- 设备: Atmel ATSAM3U4E 评估板: Atmel SAM3U-EK 编译器: CoBuilder V0.7 或 CoIDE V1.0.0 任务: lightTask 每间隔1秒钟，处理所有灯的显示 lightLedTask 当主干道上的交通灯状态改变时，改变3个LED的状态 lcdBlinkyTask 在LCD以直方图的形式上交替地显示红黄绿色 uartprintfTask 每间隔1秒钟，通过串口打印当前的交通状态和LED
super-wave
- super wave 是一个基于51单片机的一个超声波程序！-The super wave a 51 MCU-based ultrasonic procedures!
PC-communicate-with-8051-source-code
- 8051单片机与PC上位机相互通信的源代码，包含PC的C代码及8051的汇编代码-8051 PC host computer to communicate with each other source code, including the C code of the PC and 8051 assembly code
4x4keyboart
- 4x4键盘，基于51单片机，适合51单片机初学者！-4x4 keyboard, based on 51 MCU suited 51 MCU for beginners! ~ ~ ~
PPDataRTPro
- 8051单片机点对点之间的通讯程序，数据发送与接收-8051 point-to-point communication between the program, data transmission and reception
zpd
- 步进电机零位检测，NEC DX2程序，用于组合仪表电机检测-The stepper motor zero-bit detection, NEC DX2 program for the detection of combination meter motor
P-MPDataTRPro
- 8051单片机点对多点之间通讯，数据传输与接收。-Between 8051 point-to-multipoint communications, data transmission and reception.
DportRAMComm
- 在双口RAM的8051单片机之间的通讯，数据传输与接收。-Communications, data transmission and reception between the dual-port RAM 8051.
wirelessshortT
- 8051单片机实现短距离的无线通讯，数据传输与接收。-8051 to achieve the short-range wireless communications, data transmission and reception.
MSP430_CAN_mpc2510
- 用MSP４３０设计的CAN总线通讯程序，收发芯片为２５１０.-CAN bus communication procedures, the transceiver chip MSP430 design for 2510.