资源列表
GPIO
- stm32 普通io口和 第二功能io口设置 -io the mouth of the the stm32 ordinary io port and the second function
Cordic
- VHDL CODE FOR CORDIC ALGORITHM FOR COS AND SINE GENERATION
motor
- 步进电机的加减速处理，能够实现单独加减功能-The acceleration and deceleration of the stepper motor processing, separate subtraction
main
- 步进电动机控制程序段,采用汇编编程，适用于主频低的硬件平台，或者代码执行要求高的场合。-Stepper motor control block, assembly programming, hardware platform suitable for low frequency, or code execution requirements of the occasion.
arm_interrupt
- 终端实现多任务切换，包括电机的控制切换，LED灯输入任意四位一下数字作为初始计数值，具有定时功能，并可以通过LCD屏幕控制。-Terminal achieve multi-task switching, including motor control switch, LED lights enter any four numbers as the initial count value, with a timer, and can be controlled through the LCD sc
OK6410-I2C
- OK6410 I2C总线驱动分析，及应用层i2c读写程序，可使用6410开发板的camif对24lc04进行读写测试。-The OK6410 I2C bus driver analysis, and application layer i2c read and write procedures, the 6410 development board can be used to read and write tests camif of 24lc04.
vacuum-clamp
- 基于MD-PS002绝对气压监测模块的C51程序，主控芯片为STC12C5A60S2-The program STC12C5A60S2 of the MD-PS002 the Absolute Pressure Monitoring module C51
stc15F204EA
- 基于STC15F204EA的电机控制程序，包含了过零检测，调速电阻检测，及交流电机通过双向可控硅的速度控制-STC15F204EA motor control program contains over zero detection, speed resistor detection, and AC motor speed control triac
selecter
- 基于51单片机的电子称程序，其中显示部分采用TM1640，AD采样采用HX711芯片，气动机构用普通电磁阀驱动。-Said 51 microcontroller-based electronic program, which shows the part the TM1640, AD sampling HX711 chips
BootLoader_LPC214X
- nxp 214x的BOOT LOARD程序，方便大家做这方面的应用。-nxp 214x the BOOT LOARD of procedures to facilitate application to do in this regard.
st89c51-P-18B20-C51-tempratue-read
- MCU51 读取DS18B20温度的模块-MCU51 read DS18B20 temperature module
wash-machine
- 基于51单片机的洗头机程序，程序包含ISD语音芯片控制，12864大液晶控制，及4个直流电机的协同控制。程序功能主要实现自动喷水，机械手抓洗头发，及各种参数的设定等一系列功能。-51 MCU-based shampoo machine program, the program contains ISD voice chip control the, 12864 large LCD control, and four cooperative control of DC motors. The pr