资源列表
DSP-program
- dsp/bios简单开发例程，用于dsp开发初学者-dsp/bios Debug program
The-gate-node
- 这是Neuron C编写的一个门节点，使用的开发环境是LonWorks-This is written in Neuron C a gate node, the development environment is LonWorks
Touchscreen-Controlled-Wheelchair_IAR
- Touch Screen using Nintedo with Atmega32 interfaced
TC35-89c52-beta
- 通过89C52与TC35通信，短信控制继电器开关-Through the 89C52 and TC35 communication, SMS control relay switch
sms0408d
- sms0408d四位数码显示 液晶显示 直接使用 不用调试-sms0408d four digital display LCD directly without debugging
simple_count.tar
- Simple program to count and make an output blink
5PC-sends-data-to-MSP430-P6P4-1-time
- 使用MSP430F149芯片，透过串口与电脑通信，波特率9600,8数据，无校验。使用32.768k晶振，使用P3.6和P3.7口作为发送和接收口，使用异步通信USART1，采用查询形式。实现通信，当单片机接收到以S结尾以W开始的字符串时，中间的数据最好是二进制的16位，单片机会把中间的数据高八位赋值给P6口，把中间的数据低八位赋值给P4口。-MSP430F149 chip through the serial port to communicate with the computer, bau
6MSP430-sends-P-state-to-PC
- 透过串口发送给电脑p1口的状态，格式：aXXXXXXXX.对应的是P1.01234567，9600波特率-State sent to the computer through the serial port p1 mouth, Format: aXXXXXXXX corresponding P1.01234567, 9600 baud rate
8MSP430F149-sends-data-to-PC
- 使用MSP430F149芯片，透过串口给电脑发送数据，波特率9600,8数据，无校验，。发送的数据先是 MCU sends 0~127 to PC and the\\n screen will display their corresponding\\n ASCII code as follows:然后是01234567890123456789abcdefgh......,每发送一个数据回车一次-MSP430F149 chip to send data to the computer throu
51PHD7279
- 基于51单片机和HD7279的计算器设计-51 And HD7279-based calculator design
DS1302
- DS1302在MSP430F149上的驱动程序，更改ds1302.h里面的端口宏定义就可以了。时间证明很好用！ -DS1302 driver on the MSP430F149 port macro definition change ds1302.h inside. Time has proved easy to use!
DDS_AD9850
- DDS AD9850在MSP430F149上的驱动程序，电子设计竞赛必用模块。包括并行和串行两种驱动，更改相关端口宏定义即可使用。 -The DDS AD9850 driver on the MSP430F149 Electronic Design Contest will use the module. Include both parallel and serial drive, change the relevant port macro definitions can be used.