资源列表
Nokia5510LCD
- 诺基亚5110的资料与程序，程序适用于以下几款单片机：51、MSP430F149、XS128和AVR单片机-Nokia 5110 material and program, and the program is applicable to the following a few SCM: 51, MSP430F149, XS128 and AVR microcontroller
DS18B20
- 基于DS18B20的测温程序，通过液晶1602显示出来，实现实时的温度测量-Based on DS18B20 measurement procedures, LCD 1602 display, real-time temperature measurement
MSP430Pcamera
- MSP430f149实现摄像头图像采集，通过串口发送数据到电脑上，可通过串口助手才看采集图像效果-MSP430f149 realize camera image acquisition, through the serial port to send data to the computer, but through the serial port assistant will see acquisition image effect
s3c2410_ts
- 友善之臂 mini2440 触摸屏驱动程序-Friendliness arm mini2440 touchscreen driver
sy1
- 模拟输入输出,输入电压,将电压值显示在数码管上-Analog input and output, the input voltage, the voltage value is displayed on the digital
sy3
- 模拟锅炉恒温控制,温度高于设定温度就停止加热,温度低于设定温度就开始加热-Analog boiler thermostat control, the temperature is higher than the set temperature of the heating was stopped, the temperature is below the set temperature on the start of heating
sy1(1)
- 每按一次按键，累计按键次数并通过LED显示出来，且采用16进制计数。-Each time you press the button, the cumulative number of keystrokes and through the LED display and hexadecimal count.
sy1(2)
- 按1次按键 ，1个LED闪烁；按2次按键，2个LED闪烁；按3个按键，3个LED闪烁；按4次按键，4个LED闪烁。继续按下按键，则LED全灭，如此循环。-Press the 1 button, an LED flashes press 2 buttons, two LED flashes press three buttons and three LEDs flashing press four buttons, four LEDs flashing. Continue to press
sy2
- 将8个按键从0-7编号，在1个数码管上显示相应的键号。如果按键改变，则显示也相应改变。-Eight keys from No. 0-7 in the corresponding key number is displayed on a digital tube. If the key change, the display can also be changed accordingly.
test
- 此程序在keil for arm平台下编写，实现简单的led程序。-This program is written to achieve a simple led program in keil for arm platform.
test1
- 此程序只是简单的实现led的亮和灭，代码比较简单，易懂。-This program simply led turn on and off, the code is relatively simple and easy to understand.
int
- 此程序是基于ARM9平台下的外部中断实验，用按钮做外部中断-This procedure is based on the ARM9 platform external interrupt experiment, with a button to do external interrupt