资源列表
arm-fpga.rar
- arm fpga 通讯驱动代码 arm fpga 通讯驱动代码,arm fpga comunicate
pci
- PCI硬核源代码,支持33.3M的时钟频率,支持IO模式和内存模式的PCI操作-PCI operation of the the PCI hard core source code, support 33.3M clock frequency to support IO mode and memory mode
ucos-use-on-51
- 该代码成功将ucos实时操作系统移植到51单片机的硬件平台上，从而让51单片机不再寂寞不再裸跑。-The success of the code will ucos real-time operating system ported to 51 single-chip hardware platform, allowing 51 single-chip is no longer lonely, no longer run naked.
EDAjiaotong
- EDA交通灯 红黄绿左拐，四个等，不同时间，还有计时器-EDA red yellow and green traffic lights turn left, four different times, there is a timer
DS18B20
- 基于51单片机的DS18B20温度采集设计-Based on 51 MCU DS18B20 temperature acquisition design
IR-decoding-PCA
- STC12系列单片机利用PCA的功能，实现红外接收的解码工作，在LCD上显示红外解码信息-STC12 Series MCU PCA functionality, infrared receiver decoding infrared decoded information is displayed on the LCD
base-8051-proteus-C-100-examples-
- 最近在学习单片机，自己找了一篇觉得很好文档，很适合没有开发板但有点基础电路知识的开发者，里面有实例说明文档和源代码，都是很详细很全的-Learning microcontroller own a feel good documentation, it is suitable for development board no but somewhat basic circuit knowledge development, there are examples of documentation a
simplepwm
- quartusII调试，简单的pwm信号输出，FPGA初学者入门程序，高手勿进-quartusII debugging, not into simple pwm signal output FPGA beginner program, master
DSP-starter-tutorial
- DSP入门教程(非常经典)，从0开始学识DSP-DSP starter tutorial (very classic), from 0 to start learning DSP
DHT11-AVR-program
- DHT11 AVR程序，最好用AVRstudio编译（内有精确延时程序），详细分析了DHT11读取失败的可能原因！-DHT11 AVR program, preferably with AVRstudio compiled (with accurate delay program), detailed analysis of DHT11 read failure possible cause!
ID-Read
- 经过测试，完成在stc单片机上的ID卡程序读写，只需根据自己的系统晶振修改下参数就可以了！-Tested to complete the ID card program to read and write in stc microcontroller, simply modified according to their own system crystal under the parameters can be!
(12)LCD
- 利用凌阳单片机SPEC501A实现的电子时钟，在LCD上显示，通过串口发送三个数据作为时钟的初值-Sunplus SCM SPEC501A implemented electronic clock on the LCD display, three data sent through the serial port as the initial value of the clock