资源列表
VC_H264
- VC H264 Decode 开源程序,从ffmpeg移植过来,全部dll库替换成源代码.-VC H264 Decode open source migrate FFMPEG all dll lib were remove and replace by c code.
HaiSi_H264
- haisi h264解码程序,内嵌说明文档,很容易上首,解码速度比较快-Haisi H274 Decode source code for vc with spec, fast speed, easy to use.
USART1
- stm8s的串口驱动stm8s的串口驱动-stm8s uart driver source code ST
TIME1_pwm
- stm8s tim1的pwm输出源文件，来自官方-stm8s tim1 pwm source code
1.1.1
- 基于STM32的GPIO相互连接，实现设备之间的相互通信-Connected to each other based on the STM32 GPIO, communicate with each other between devices
KBI_C
- 按下键盘按键,串口发送对应的键值 键盘中断,键盘扫描,键值识别,键值转换 -Press the keyboard keys, serial port to send the corresponding key Keyboard interrupt, keyboard scanning, identification keys, key conversion
LCD_C
- 本工程为液晶显示，在pc端输入32个字符，送LCD显示，并且把收到的数据立即回发 (1)初始显示: Wait Receiving.. Soochow 2010.09. (2)MCU等待接收PC发来的32个字符,并送LCD显示 -This project is a liquid crystal display in the pc-ended input 32 characters, send LCD display, and the data receive
CT107D
- 用于CT107D开发板的例程与原理图、说明书，其中包含温度、显示、按键等典型模块的例程，已编译通过。-CT107D for routine development board and schematics, manuals, which includes temperature, display, buttons and other typical routine modules, compiled by.
STM8-from-entry-to-masterV1.0
- STM8 entry to masterV1.0-STM8 entry to masterV1.0********************
Candle
- 使用Feeling单片机开发的红外遥控控制的七彩渐变和跳变的程序- 使用Feeling单片机开发的红外遥控控制的七彩渐变和跳变的程序 使用Feeling单片机开发的红外遥控控制的七彩渐变和跳变的程序 Using Feeling microcontroller development of the infrared remote control of the colorful gradient and jump procedures
dian-ping-yu-jing
- 用stc单片机制作的 12伏汽车电瓶预警器，在汽车电瓶电压，降到一定程度时，语音提示，现在电瓶是处于严重亏损呢！还是需要启动发动机充电，-With stc MCU production of 12-volt car battery warning device in the car battery voltage, down to a certain extent, the voice prompts, the battery is now in a serious loss of it! St
k_thermocouple
- K型热电偶基于C8051F350采集温度，并转换为4-20MA标准信号-K type thermocouple based on C8051F350 collection temperature, and converted into a standard 4-20 ma signal