资源列表
jydjbj
- C51程序，把控制器程序已经用在产品上。包括定时器的使用，步进电机的控制技巧-C51 program, the controller program has been used in the product. Including control techniques timer, stepper motor
SC95869-MP3-USBaSD.SI4702_TUNE
- 95869+si4702的MP3电路，正常使用中-SC95869 MP3 USB&SD.SI4702_TUNE.sch
sh86310_d1_v5.40_lib004.3
- 中颖sh86310的mp3程序，正常使用中-sh86310_d1_v5.40_lib004.3 MP3程序
bjmd
- 包含单双八拍，双四拍的步进电机的加减速控制。 -Mono contains eight beats, acceleration and deceleration control dual four-beat stepping motor.
gd
- 包含四线步进电机的正反转控制程序以及原理图和电路图。-It contains four-wire stepper motor reversing control procedures as well as schematics and circuit diagrams.
SH86311_312_SCH
- 中颖MP3电路原理图，与上传的程序配套使用-SH86311&312 SCH
main
- 点亮LED灯，通过配置时钟的边缘信号来点亮led灯，注意的是对于每个边缘存在延时时间，也就是每个灯点亮的时间。-Lit LED lights, you can configure the clock edge signal to light led lights, noted that the delay time for each edge of existence, that is, each time the lights.
shengrikuaile-
- 在51单片机上循环播放祝你生日快乐的音乐程序源代码-On the 51 single chip microcomputer looping music program source code, I wish you a happy birthday
SH310_EV_PIN
- 中颖MP3上传程序资料，与上传的程序配套使用-SH310 EV PIN
12864
- msp430单片机12864驱动函数集，支持绘图，字模，反白绘图，反白字模，坐标定点跳转等功能-The 12864 microcontroller MSP430 driver function set, support graphics, fonts, anti white drawing, inverse matrix, coordinate point jump function
DS18B20
- msp430单片机DS18B20驱动函数，可直接使用-MSP430 MCU DS18B20 drive function, can be used directly
main
- 定义不同RCC的系统时钟频率，让LED流水灯交替闪烁的速度不一样，注意后面要加上延时效果。-Define different RCC system clock frequency, the LED lights flash alternately flow velocity is not the same, pay attention to the back to add delay effects.