资源列表
keil
- 一、单片机点亮8个发光二极管实验 1）P1口外接8个共阴极发光二极管，点亮高4位； 2）p0口接8个共阳极发光二极管，点亮高4位； 3）P0口接8个共阴极发光二极管，点亮高4位；-A single chip lit 8 light-emitting diode experiment 1 (P1) 8 common cathode light-emitting diodes, light up to a high of 4 2) P0 port to con
keil
- 单片机点亮数码管实验（不能用定时器功能） P0口接1个八段式共阴极LED数码管，通过调用延时子程序，循环显示0-9，时间间隔自定，注意使用一维数组给出显示代码-MCU lit digital tube experiment (can not use the timer function) P0 port connected to the 1 paragraph of the common cathode LED digital tube, by calling the delay sub
keil
- 3）P0口接2个八段式共阴极LED数码管，片选信号分别接P1.0，P1.1，让两个数码管显示数字57；-3) P0 port 2 eight segment common cathode LED digital tube, chip signal are respectively connected with the P1.0, P1.1, two digital tube display digital 57
keil
- 4）P0口接2个八段式共阴极LED数码管，片选信号分别接P1.0，P1.1，让两个数码管动态显示01直至10共计10个数码，再重新循环，数字持续时间自定；- 4) P0 port 2 eight segment common cathode LED digital tube, chip signal are respectively connected with the P1.0, P1.1, two dynamic digital display 01 to 10 a total of
keil
- 外部中断实验!!! 1）p0口接8个发光二极管，共阴极接法，要求：如果外部中断0维持接低电平，则8个二极管保持全灭状态，一旦外部中断0接高电平，则8个二极管恢复保持全亮状态； -External interrupt experiment!!! 1) P0 with 8 light-emitting diodes, commoncathode, requirements: if the external interrupt 0 maintain the low level, th
keil
- p0口接8个发光二极管，共阴极接法，要求：如果外部中断0维持接低电平，则8个二极管保持全灭状态；如果外部中断1维持接低电平，则8个二极管保持全亮状态；如果两个外部中断端口同时接为低电平，则二极管全亮；如果两个中断源都接高电平，则8个二极管中，高4位亮，低4位灭；-Port P0 is connected to 8 light-emitting diodes, commoncathode, requirements: if the external interrupt 0 maintain the
HT_AN_SHT3x_Sample_Code_V1_D1
- 使用SHT3X传感器进行温湿度采集 多开发系统支持，只需修改SYS文件即可-Use SHT3X sensor for temperature and humidity acquisition, use STM32F103 for data processing
stm32-HTU21D
- 文档内含有HTU21D温湿度传感器的驱动文件，STM32可用-The document contains the HTU21D temperature and humidity sensor driver files, STM32 available
PCB1.~(1).PcbDoc.Zip
- 电子设计竞赛的DCDC压降版图和L298N驱动电路版图1-Electronic design competition DCDC pressure drop layout and L298N drive circuit layout 1
arm4u_latest.tar
- DESIGN OF A DYNAMICALLY RECONFIGURABLE PIPELINED RISC PROCESSOR
CH240128
- C51单片机+LCD240128液晶屏源码，非常有用。-C51 MCU and LCD240128,This is very good job.
STC15_USART
- STC15F2K32系列串口通讯实现，接收HEX码，输出字符串，波特率19200，8位数据，无检验，停止位1-STC15F2K32 serial communication, receive HEX code, the output string, baud rate 19200, the 8 bit data, no test, stop bit 1