资源列表
步进电机驱动
- 使用STM32F103系列单片机，简便的步进电机驱动代码(Simple stepper motor driver code)
7SEG LED segment
- 7段数码管显示程序PIC单片机，通过扫描显示，实现6位数码管显示，(7 segment digital display program, PIC microcontroller, through the scanning display, to achieve 6 digital display,)
duojitest1
- 舵机提供+90-90度旋转，自动来回转动，精确到1度，每秒旋转1周期。(The steering gear provides +90-90 degrees of rotation, automatically turns back and forth, accurate to 1 degrees, rotates 1 cycles per second.)
DTH11_1STC10F08
- STC 单片机和DTH11温度和湿度模块，实现串口通信，实时显示温度和湿度(STC microcontroller and DTH11 temperature and humidity module, to achieve serial communication, real-time display of temperature and humidity)
128128wendu3
- 通过STC10F08单片机驱动液晶显示屏，LCM芯片型号为US1617S(Through the STC10F08 microcontroller drive LCD screen, LCM chip model is US1617S)
hongwai
- 红外遥控译码Infrared remote control decodingInfrared remote control decoding(Infrared remote control decoding)
saveToUSB_mbedppBOARD_uvision5_lpc1768
- save txt file to usb using mbed application board
ultranging
- 读取ds18b20温度，并在LCD上显示(Read the DS18B20 temperature and display on the LCD)
PIC16F876 滚动码收吗解码C程序
- PIC16F876 滚动码收码解码C程序,可实现固定码与|滚动码两种接收方式(PIC16F876 rolling code charge code decoding C program, which can realize the fixed code and | rolling code two reception mode)
Keil_XMC1300_UART_1302
- xmc1300串口程序，程序已经测试，可用。(DEscr iptION: This example toggles one on-board LED using a 200ms Systick interrupt base and sends UART messages to the PC. REQUIREMENTS: - J-Link Drivers installed on PC - J-Link v4.59 or above - XMC1300 Boot Kit (XMC1
can
- can总线非常有用的资料，包括Can总线的RTL代码(files is very useful information of Can bus, RTL code is including in the files.)
实验1 - GPIO输出控制LED
- 配置NRF51822的I/O口实验，用I/O控制LED灯(allocation; configure; collocation; deploy)