资源列表
Sensor data processing
- 处理传感器数据的程序，例如测距传感器。去掉一个最大值，去掉一个最小值，然后8个数据取平均值。结果去除了部分噪声，减少了误差。(program that deals with sensor data, such as a range finder. Remove a maximum, remove a minimum, and then take the average of the 8 data. As a result, partial noise is removed and error i
jtag fsm
- jtag接口的状态机实现，李庆华《通信IC设计》随机代码(State machine implementation of JTAG interface)
1-uCOS-II+LED（单任务）
- 在stm32上一直的uCOS-II+LED（单任务），可以直接编译的(The uCOS-II+LED (single task) that has been on STM32 can be compiled directly)
2-uCOS-II+LED（多任务）
- 在STM32上一直的uCOS-II+LED（多任务），可以直接编译(The uCOS-II+LED (multitasking) on STM32 can be compiled directly)
beep
- 合泰单片机简易TM使用，产生方波用于驱动无源蜂鸣器(Holtek MCU simple TM use)
USB_Camera
- USB 视频采集模块，基于v4l2，非常好用(USB video capture module, based on v4l2, very easy to use)
摇摇棒
- 摇摇棒的相关配套资料，用于制作一个建议的显示图案或汉字的摇摇棒(Shake rod related information for making a suggested display pattern or Chinese character shaking stick)
STC_EEPROM延长使用寿命的大数据记录C程序
- 在文档里面，有j经过验证的C程序，主要用于解释STC的单片机里面的eeprom的使用效率和延长寿命的程序。(In the document, there are proven C procedures, mainly used to explain the STC microcontroller EEPROM inside the use of efficiency and extend the life of the program.)
单片机长短按键_很好_
- 这是我看到过的最详细的介绍,比好多的教课书讲的要清楚,明白,详细,易懂的多。(This is the most detailed introduction I have ever seen, which is more clearly understood, more detailed, and easier to understand than many teaching books.)
temp
- 通过DS18B20读取温度并进行处理，通过LCD1602显示温度，可自行设置温度上下限，超限报警，可将温度上下限存入EEPROM,基于51系列单片机(Read through the DS18B20 temperature and processing, through the LCD1602 display temperature, you can set the temperature limit, overrun alarm, you can lower the temperature l
stc12_eeprom
- STC12系列单片机掉电存储程序，在官方的基础上优化(STC12 series single chip off electricity stored program)
ChuShiqi
- 采用QT编写的一个温湿度读取的界面软件。采用C++编写(Interface display code)