资源列表
SwiftProForArduino-develop
- 这个是UArm的开源控制软件 以及固件 对于参考机器臂开发很有帮助。定位精度已经达到0.2mm 而且 还有手势教学功能(This is UArm's open source control software and firmware, which is very useful for reference robotic arm development. Positioning accuracy has reached 0.2mm, and gesture teaching function)
uArmCreatorStudio-master
- 上位机软件 也是开源的 ，带3D直接视图功能，直观显示轨迹 与图形化变成(The host computer software is also open source, with 3D direct view function, intuitive display of trajectory and graphics into)
paral
- verilog avr algorithm avr
CAN
- STM32F207 CubeMX HAL CAN
MT6737_SPI_ads7871.tar
- MT6737平台安卓7.0系统调通ADS7871，走的是SPI通信，调试ADS7871的可以参考，在MTK平台调试SPI的同样可以参考(MT6737 platform Android 7 system tune ADS7871, go is SPI communication, debug ADS7871 can refer to, in the MTK platform debugging SPI can also refer to)
三轴加速度传感器实验
- 基于STM32单片机的三轴加速度检测程序(Three axis acceleration detection program based on STM32 microcontroller)
BS83B12A_20160607LIBV413--V3
- BS83B12A 触摸程序源码，从合泰代理处获得。(BS83B12A TOUCH IC souse code)
dds6_ise12migration
- 以DE2为开发平台，采用Veriolg语言编程，实现了DDS信号输出，频率，步进，波形输出均可调，采用Modelsim以及FPGA内嵌逻辑分析仪验证设计的正确性，可以满足一定的工程需求。(With DE2 as the development platform and Veriolg language programming, the DDS signal output, frequency, step and waveform output can be adjusted. The corre
CRC
- CAC16 cac校验程序 modbus用(cac16 CAC check program MODBUS)
项目实战2 - 数字温度计（DS18B20正负温显示)
- 数字温度计（DS18B20正负温显示) keil(Digital thermometer (DS18B20 positive and negative temperature display))
sht10
- lpc2346驱动sht10 程序 测试了 可以用(Lpc2364 driver SHT10 program tested, you can use)
MSP430G2553_sht10
- msp430G2553驱动sht10 实测可以使用(Msp430G2553 drive SHT10 measured can be used)