资源列表
OLED显示例程
- 插上OLED屏，上电后通过OLED屏幕观察结果。 旋转编码轮可以看到OLED屏中间 Count 计数器的值进行+1或-1变化。 按下旋转编码器（OK键），可以切换OLED屏显示方向（正向或倒180度） 按下Cancel键，切换到白屏状态，方便检查屏幕是否有黑点。再按一下切换会主界面。(THE PRESENT FIRMWARE WHICH IS FOR GUIDANCE ONLY AIMS AT PROVIDING CUSTOMERS * WITH CODING INFORMAT
code
- 一些小功能，网上自己玩的，单片机之间通信。(Some small functions, online play, communication between the MCU.)
STM32F0(SysTick)
- stm32f030 systick 工程模板(stm32f030 systick stm32f030 systick)
OpenLoopSenBLDC.X
- dsPIC30F4011 電機控制開發版相關資料 開迴路驅動控制(DsPIC30F4011 Related information of motor control development Edition Open loop drive control)
led_test
- 基于Verilog硬件语言的流水灯设计，可以实现4个led灯按照流水灯的形式闪亮。(ased on the flow lamp design of Verilog hardware language, 4 LED lights can be realized in the form of flowing light.)
ClosedLoopSenBLDC OLED.X_ld
- dsPIC30F4011 電機控制開發版相關資料 閉迴路驅動控制(DsPIC30F4011 Related information of motor control development Edition close loop drive control)
三维ANC
- 三维空间主动噪声控制研究，内含参考文献及算法。(The study of active noise control in three-dimensional space contains references and algorithms.)
123
- 使用IAR编译环境，在stm32开发板上，读写MPU6050寄存器，测量角度，(Using the IAR compilation environment on the STM32 development board,Read and write theMPU6050 register to measure the angle)
ht1261
- ht1261芯片的驱动，可以用此芯片驱动LCD屏(The ht1261 drive, it will be used to drive the LCD)
L289N驱动程序
- L298N驱动程序书，驱动电机，可驱动多个电机，能实现正反转(L298N driver book, drive motor, can drive a number of motor, can achieve positive and reverse)
add
- 一个简单的半加器，包括图形编辑方法，并已下载(A simple half adder, including graphics editing method, and has been downloaded)
try
- 一个有关QT的小程序1233211234567(12332145678998755522113)