资源列表
AURIX iLLD Demos v1.0.1.0.0
- TC23 Demo程序，各个模块的，学习使用(TC23 Demo,Each module, learning to use)
camera_ov7725_sample
- 实现摄像头ov7725采集视频，通过vga端口输出. fpga型号为EGO1，可以自行修改xdc文件.(Realize the camera ov7725 acquisition of video, output through VGA port. Fpga model EGO1, you can modify the XDC file.)
crazepony-firmware-none-test_original_baro
- 开源飞控crazypony的最新版源码，采用卡尔曼滤波精心六轴数据融合，实现有头模式无头磨回事，光流定点，(The latest version of the source code of open source flight control crazypony uses Kalman filter to elaborate six axis data fusion to realize the headless grinding of head mode and fixed point of
基于STM32F1的 MPU6500四元数姿态解算代码
- 单片机采用STM32F103，SPI通信方式，通过四元数解算直接获得欧拉角。姿态角稳定。
1.全向轮小车源码
- 遥控控制麦克纳姆轮小车，使其进行全方位的移动(Remote control mcnamm wheel car to make it move in all directions)
MPU6500研发代码(四元数)
- 基于STM32F103单片机解算出MPU6500 陀螺仪姿态数据，SPI通信协议，并且CAN总线输出。(Based on STM32F103, the attitude data of mpu6500 gyroscope, SPI communication protocol and can bus output are calculated.)
第七届国赛 电压频率采集设备
- 第7届电压频率采集设备，程序齐全，直接上电就可以测试！！！(The 7th voltage and frequency acquisition equipment, complete procedures, can be tested directly on the power)
第六届模拟题 简易温度采集与控制装置
- 第六届模拟题 简易温度采集与控制装置，程序源码齐全，上电即可测试！！！(Simple temperature acquisition and control device for the sixth simulation question, complete source code of the program, power on and test)
MOABC
- 建立了关于主轴转速和轴向切削深度的关系图(The relationship between spindle speed and axial cutting depth is established)
RN8209D单相电表程序
- RN8209D单相电表对电压、电流进行采样，通过USART或SPI进行传输到单片机，能够精确测量电压和电流，多应用于电表方面。
合泰HT1382实时时钟驱动C程序
- 本人自己写的HT1382驱动C代码,经过了认真测试。主控芯片选用合泰HT46R003，用仿真器调试和验证。代码简洁有详细注释,功能完整。有需要的朋友推荐下载哦！
哈夫曼
- 一种用verilog语言实现的霍夫曼压缩编码算法(Huffman compression implemented by Verilog)