资源列表
DSP编程指令集
- 详细讲解了c54的指令集，所有的资料和表格都从ti的帮助文件中截取。-C54 detailed account of the instruction set, all the information and forms from the help files ti interception.
ppp-2.4.1
- 经典的ppp程序，适合嵌入式linux下的应用-classic PPP program,which adopts to the application in the embedded system \"uclinux\"
tp_gui
- 检验gui程序的例子，适合嵌入式和linux操作系统-gui testing procedures example, and for embedded Linux operating system
触摸屏校准方法
- 触摸屏校准方法，适合嵌入式linux下使用-touch screen calibration method for embedded Linux use
读电机码盘的程序
- 读取一个电机码盘信号，里面有对串口读写，对控制寄存器读写的代码。入门级！-read a motor encoder signals, and they read and write to serial port, the control register read and write code. Entry-level!
mm36sb020
- mm36sb020存储器与单片机连接时的读写程序！里面还包含了与单片机的接口！-mm36sb020 They also include interface with microcontroller!
单片机主板监控程序
- 系统的最小板程序，可以作为其他开发的基础！可以通过键盘控制！-the smallest board procedures, can be used as the basis for other development! Keyboard control can!
电机调速控制程序
- 电机调速的控制程序，你可以通过这个程序来设定参数，通过反馈就可以控制速度了啊！-of motor speed control procedures, you can use this procedure to set parameters, feedback can control the pace of their ah!
电梯控制程序
- 把程序写进单片机从而控制电梯的上下，开关门，报警等功能！这个程序简单，使用性强！-procedures written into the MCU control of the elevator up and opening the doors, alarm functions! This simple procedure, the use of strong!
doc_ucosii_data_m8_iccavr_by_yfang2
- ucos-ii 编译器ICCAVR CPU atmega8 8M 晶振 对原作者的ucos进行了简化，去掉了 hook，保留了基本功能 代码精简，编译后代码占 mage8 的 49% 时钟使用timer2，中断时间为2 ms 任务1：刷新LED，检测按键，调整时间 任务2：计时，串口发送 9600 bps--UCOS-II compiler ICCAVR. It simplifies original UCOS by removing hook, but it keeps basic funct
实时时钟-单片机
- 采用定时器中断的方法，设计一个一天24小时进制的实时时钟；用6个发光二极管分别显示时、分、秒的记时； 能进行整点报时。可以从键盘中预置、修改时钟值。含有硬件设计图-timer interruption using the method to design a band 24 hours a day in real-time clock; With six light-emitting diodes showed the hours, minutes, and seconds to the ent
DSP各种应用实例1
- 英文版。关于DSP一些应用的介绍。包括：Motor Control、Digital Cellular Basestations、ADSL-English. Some of the DSP application presentation. : Motor Control, Digital Cellular Basestations, ADSL