资源列表
step_driver_ln298
- 本驱动程序主要针对L298驱动的步进电机，用MSP430单片机编写，在自动控制设计中应用广泛，且有较好的驱动功率。-The main driver for the L298 stepper motor driven, with the MSP430 microcontroller is written in the automatic control design is widely used, and there is a better drive power.
new_5_12
- pic单片机 空调加热器工程文件 含PID算法 C语言-pic microcontroller project file containing air heater PID algorithm in C
ISE-12.3-Guide
- 本文为ise12.3详细开发步骤，对新手会非常有帮助的。-This article ise12.3 detailed development steps, the novice will be very helpful.
AD603-TL5615
- 基于51单片机的，通过DA TL5615输出电压，控制宽带高增益压控放大芯片AD603的放大倍数。放大倍数由DA输出电压与AD603的另一固定的参考电压之差共同决定-Based on 51 single-chip, through the DA TL5615 output voltage, control voltage-controlled high-gain broadband amplifier chip AD603 magnification. Magnification with th
music-and-LCD
- 音乐与PWM数值的显示。在放音乐时，会有音乐声音发出，同时显示音频设置的数值。-music and The PWM ORC1A number appear.
MODBUS
- 威纶通 显示屏 与单片通信典型程序，解决显示屏必须用PLC控制问题。-Wei Lun through the display and the typical single-chip communication program
signal
- 5110液晶显示子程序 用于初学者学习和参考，内容包含有显示字符，汉字，图片等-5110 display
KEY
- avr 矩阵键盘的扫描 iccavr 编写-avr keyscan
AD7829
- AD7829是8位并行A/D转换芯片，这是在keil中调试的程序，主控为51单片机。-AD7829 is the 8-bit parallel A/D converter chip, which is in the debugging program in keil, 51 master microcontroller.
LCD_SegmentsDrive
- st8l152控制液晶的源程序，c编写，调用st库-st8l152 control LCD source, c write, call st library
MSP430_TEST
- CPU:MSP430F54系列 完成uc_os的移植 目前只支持64K以下的flash访问-CPU: MSP430F54 series completion uc_os transplantation is currently only supports up to 64K below the flash access
Vot
- TINA下绘制的用电压互感器采集220v电压信号的隔离放大电路。前级利用2mA/2mA电压互感器采样，将电压放大至0~3V。-TINA drawn under the acquisition with a voltage transformer 220v voltage signal isolation amplifier. Pre-sampling using 2mA/2mA voltage transformer, the voltage is amplified to 0 ~ 3V.