资源列表
sopc_cpu
- 此例程是基于FPGA的SOPC工程实例，是对CPU操作运用的一个很不错的程序，内有modelsim仿真激励，都是测试过的好程序-This routine is FPGA-based SOPC engineering practice, the use of CPU operation is a very good program, there modelsim simulation stimulus, good procedures are tested
TX-1C(C51)
- 郭天祥_十天学会单片机和C语言编程-讲课中涉及源程序-Guo Tianxiang _ ten days learn microcontroller and C programming language- the source involved in lectures
CanFestival-3-48bff18fc546
- can open statck protocol source code
RS485-communication
- RS485的一个非常好的程序，MODBUS通讯协定及RS485介面通讯模式-RS485 is a very good program, MODBUS communication protocol and RS485 interface mode
MPPT_c-programme
- MPPT最大功率跟踪算法，用C语言编写的。-MPPT—c Programme
canbus
- 实现CAN总线的通信，并通过测试验证，用verilog在FPGA上实现-CAN bus communication, and tested to verify that, in the FPGA using verilog
lcd_dsp
- verilog编写的串口和液晶驱动的程序。ＦＰＧＡ接收串口的数据，然后在液晶上显示，用的是黑金开发板。-verilog prepared by the serial and the LCD driver program. FPGA receives serial data, and then in the liquid crystal display, with the black gold development board.
语音智能车控制程序
- 语音智能车控制程序，实现人对智能车的起停和左右转等功能，运用到了语音识别，语音压缩，语音播报等知识。-Intelligent voice control car program
CH376_test
- 基于STM32内部的SPI模块通过CH376芯片进行与U盘进行数据交换，通过该程序可以了解文件系统知识。-Based on STM32 internal CH376 chip SPI module to exchange data with the U disk, through the program can understand the file system knowledge.
C2000_-Flash_Write
- 介绍DSP2000的FLASH烧写方式，包含JTAG及串口两种方式的介绍。-Introduction DSP2000 FLASH burning methods, including JTAG and serial introduction of two ways.
发光二极管亮灯时间控制程序
- 发光二极管间隔300ms先奇数亮再偶数亮,循环三次,一个灯上下循环三次,两个分别从两边往中间流动三次,再从中间往两边流动三次,8个全部闪烁3次,关闭发光管,程序停止-Interval of 300ms LED light and then even the odd first light, cycle times, a light cycle up and down three times, two each from the three sides to the middle of flow,
简易低频信号源的设计
- 简易低频信号源的设计，简易低频信号源的设计，供大家参考，一起学习-Simple design of low-frequency signal source, the design of simple low-frequency signal source, for reference, learning together