资源列表
Button_Change_Pwmdty
- 按键改变pwm占空比在stm32上的实现-Button to change the pwm duty cycle to achieve on the stm32. . . . . .
The-speed-table
- 用单片机设计的测速表源程序。测量转速，使用霍尔传感器，被测轴安装有12只磁钢，即转轴每转一周，产生12个脉冲，要求将转速值（转/分）显示在数码管上。-The speed table with a single-chip design source. Measurement speed, the use of Hall sensors, the measured shaft with 12 magnets, one revolution of the shaft each produce 12 p
实现电机SPWM控制
- 实现电机SPWM控制，适用于大部分异步电机，如用于同步电机，需变频启动-The motor SPWM control for most of the induction motor, such as for synchronous motor, the need to start conversion
PVD
- stm32f103zet6 的低电压中断程序，电压阈值为2.9v，开发环境KEIL-the PVD interrupt of stm32f103zet6,the threshold is 2.9 volts.The environment is RVMDK.
DDR-SDRAM_IP_core
- DDR-SDRAM接口模块verilog源代码，可用作IP核使用，已在FPGA上验证-DDR-SDRAM interface module verilog source code, can be used as IP cores to use, proven
bo-xing-fa-sheng-qi
- 这个源码是基于8051F410单片机的PWM波形发生器，程序使用中断方式，大大节省了单片机资源-This source is based on 8051F410 microcontroller PWM waveform generator, the program uses interrupt, saving the microcontroller resources
wenkonglu-arm-shangweiji
- 在S3C2410上实现QT上位机的开发，主要显示温控炉文档，并控制电机的打开-To achieve the S3C2410 QT PC development, the main document display temperature-controlled ovens, and control the motor to open
Qt4Code
- 上传的是有关于QT4书中的配套代码，希望对初学者有所帮助-Attached is a complete book on the QT4 code, I hope to help beginners
Carlinght
- 小车寻光，向光源方向前进，我用的是普通的光敏电阻制作的模块，输出地是数字信号，要自己做个灯盏，这样才能有导向性-Car search light, the light source direction, I use the normal production of photosensitive resistor module, the output to a digital signal, it has to be a lamp, so as to have oriented
STM32_DAC
- keil编译 stm32 dac 波形发生器-keil compiler stm32 dac Waveform Generator
module_param
- module_param 内核模块实例，带参数，演示了如何向模块传递整形、长整形、字符串等参数-module_param kernel module instance, with the parameters, the module demonstrates how to pass integer, long integer, string and other parameters
TCPhotoManager
- 基于TCC89x_Magellan_WinCE600图片浏览程序c++源码-Based on TCC89x_Magellan_WinCE600 picture viewer application c++ the source code