资源列表
ARMJTAG-and-penjtag-esource
- ARM的JTAG调试原理 含Openjtag和GIVEIO的程序源码 可用于自制wiggler 和参考PC机外设编程接口-JTAG debugging with ARM-principle procedures Openjtag and GIVEIO wiggler source and reference for self-programming interface PC Peripherals
C_Keil51
- 一种利用的功能来实现51单片机用户程序的方法。使用这种方法，无需任何硬件仿真器，甚至都不需要用户电路板。所需的只是： ① 硬件。1台普通计算机 串口软件可以是自己编写的专用调试或上下位机通信软件，也可以是通用的串口软件(如串口助手、串口调试等)，主要用来收发数据-To achieve a functional use of 51 single-chip user procedures. Using this method, without any hardware emulator,
MCUCLOCK
- 单片机编程 C语言编程实现电子时钟 属于单片机入门级实例 自己写的 希望有所贡献-Microcontroller Programming C language programming electronics microcontroller clock is an instance of the entry-level to contribute to their own wish to write
zongtu
- 基于单片机的红外遥控电子密码锁 本设计以单片机AT89C2作为密码锁-Microcontroller-based infrared remote electronic locks as the design of a microcontroller AT89C2 Lock
mimasuo
- 密码锁相关单片机程序及电路，实现8位密码识别判断-SCM password implement
c_wp260
- 利用 Xilinx FPGA 和存储器接口 生成器简化存储器接口-Using Xilinx FPGA and the memory interface generator to simplify memory interface
uart
- 51单片机串口通信，为了实现简单的串口而编写的，希望对大家有用。-51 microcontroller serial communication, in order to achieve a simple serial port and write, and I hope useful.
TQ2440-TEST
- 天嵌开发板TQ2440的示例程序，C语言编写，开发环境为ADS1.2，里面实现了多个功能，初学ARM9的可以看看借鉴一下。-Days embedded development board to run the sample program TQ2440 nude, C language development environment for ADS1.2, processor S3C2440.
test_delay_of_microchip
- delay function for pic microcontroller and have header file ( mahmoud.h ) to make your c code accept small letters
UserProg
- 采集器程序，通过读取固定长度的条码，从而采集数据保存到采集器中，然后上传到电脑里。-Collector program by reading a fixed length of the bar code to collect data to the collector, and then uploaded to the computer.
dsp-exp3
- 数字信号处理的一些基本知识以及，用MATLAB实现的程序-Digital signal processing and some basic knowledge, with the MATLAB program to achieve
uart
- 采用VHDL语言编写的串口驱动程序，已调试通过，能够实现同PC机的数据传输，可读性好，可移植性好-VHDL language using the serial driver has been debugged, to achieve the same PC, the data transmission, readable and portable