资源列表
DE2
- DE2开发板的全套资料，包含例程，原理图以及接口介绍文档等！-DE2 development board of the full set of information, including routine, schematic and interface descr iption documents and so on!
gardner
- 用Gardner算法时钟同步的BPSK的源程序-Gardner algorithm for clock synchronization with the source code BPSK
chuan2
- 用verilog HDL编写的并串转换模块，在ISE软件仿真过，也可综合-Prepared using verilog HDL and string conversion module, in the ISE software simulation, and can also be integrated
pwm
- MSP430用定时器控制生成PWM波形。波形占空比可调。-MSP430 PWM waves generated by the timer control. Waveform SHCH adjustable.
u-blox5_Protocol_Specifications(GPS.G5-X-07036).r
- UBX protocol specification for u-blox 5 receiver.
Keil
- 周立功LPC1766开发板适用的Keil工程模板，分为两部分不：一般程序和带有ucos操作系统的模板，内有ucos移植代码-Zhou Ligong LPC1766 development board to apply Keil project template, is divided into two parts: general procedure and with the UCOS operating system template, within the UCOS transplant c
11317221324C1024
- 24c1024读写程序 结构完整 灵活 可支持的硬件丰富-24c1024 to read and write procedures
BTLCLC
- MSP430串口波特率计算工具，可以根据输入频率和要设置的波特率自动计算出UBR1、UBR0、UMCTL的值。-MSP430 serial baud rate calculation tool, you can set the input frequency and the baud rate to automatically calculate the UBR1, UBR0, UMCTL value.
SPIOFSTM32
- STM32的SPI通信程序，两片STM32之间通信成功，主收从发-STM32 of SPI communication program, the successful communication between two pieces of STM32, the main income from Fat
CPLD_EJTAG_0_1_.1.0.1427
- jtag tool with st20 support
set-FTP-server
- VxWorks视频-配置FTP server-VxWorks
Interrupts
- c8051f320的中断操作官方测试程序-interrupt test program for the c8051f320