资源列表
keil2440-uCos-GUI390
- MDK 平台S3C2440 ucos 的移植包含不错的GUI界面-MDK platform S3C2440 ucos transplant contains a good GUI interface
RT-Thread-0.3.1
- stm32f107 RT-THREAD例子，移植了触摸屏-stm32f107 RT-THREAD example, transplantation of the touch screen
ucos_fs_gui
- ucos系统+file文件系统+GUI显示器接口 系统源码-ucos system+ file file system+ GUI display interface system source code
sanxiangyibudianji
- 个人编写的三相异步电机ＤＳＰ驱动程序，已通过实验验证的。-Personal preparation of three-phase asynchronous motor DSP driver, has been verified by experiments.
sanxiangyibu
- 已通过调试的三相异步电机DSP2812闭环控制驱动程序。-Through debugging three-phase asynchronous motor closed loop DSP2812 control driver.
omap-l137_nandflash
- omap-l137的flash烧写程序；好东东哦-omap-l137' s flash Shaoxie procedures good Dongdong oh
ISCASBenchmark2
- 长126页的ISCAS benchmark。包括原理图，代码和测试数据。-Length 126 of ISCAS benchmark. Including schematics, code and test data.
JIBUQI
- 简单计步器报告,内涵原理图、实物照片、及C源程序代码-Simple pedometer report, meaning the schematic, real photos, and C source code
yuv2rgb001
- yuv2rgb, 一个老外写的arm上yuv转换rgb的库，支持YUV422,420P,到RGB32，RGB24,RGB16的转换。针对arm写了汇编优化，性能较高-yuv2rgb library in ARM CPU. Both C and assemler source.
ARM+PROTEUS
- PROTEUS下仿真ARM应用系统，支持UCOS操作系统。-PROTEUS under the ARM simulation applications, operating system support uCOS.
SPWM
- 斩波电路源程序！C8051F410调试成功-Chopper source! C8051F410 Debug success
PLC_UART_Communication
- S7-200的发送、接收程序，可以和PIC单片机通信，通过通信口控制PLC触点-the code of transmiting or receiving UART signal in S7-200 PLC, which can be connected to PIC or other MCU, and by which ,PIC can control the ON or OFF status of PLC output