资源列表
FFT_fixedPoint_console
- 定点复数FFT算法 C语言实现 支持点数为128,256,512,1024,2048可配置 同时附带文档-Fixed-point complex FFT algorithm for C language support 128,256,512,1024,2048 points can be configured at the same time as the document attached
Uart
- Uart source in CCS 3.3 C5507
13-2
- 单片机接有LCD液晶显示器，开机后在液晶显示屏第一行显示“OK”-Then there are single-chip LCD liquid crystal display, boot in the first line of LCD display " OK"
cezhuangguiok6
- 对测桩数据，计算其有效参数（桩长或波速）。并绘出测桩波形及桩身示意图。是很好用的测桩软件。-Pile on the measured data, calculate the effective parameters (pile length or velocity). And draw and pile measured waveform diagram pile. Is a very good software to use the test pile.
video_loopback
- video loop back source code. in CCS 3.3 davinci-video loop back source code. in CCS 3.3 davinci..
u-boot-270-lcd.tar
- 针对yassylcd的uboot源码，lcd驱动实现简单的图形显示-Yassylcd for the uboot source, lcd drive to achieve a simple graphical display
12864A-3
- 12864液晶在出厂时其对比度已经调好，所以用户在使用的时候第三管脚可不用接任何东西.-12864 LCD contrast, when the factory has a good tune, so when users can not access the third pin anything.
4-LED-2
- 使用PIC控制3个4LED数码管并联延时显示数值的程序-to contril led with pic
Recorder1
- EVC下的小录音程序，不保存文件的，只放BUFFER里面-EVC，recoder ,platform builder,wince5.0
How_to_Design_a_Xilinx_PCIe_Solution_with_DMA_Engi
- PCI-E接口设计是现在系统设计的热点，本文档是在xilinx芯片中集成pcie接口控制器的好资料-how todesign a xilinx PCI-e solution
RPK_V1.0
- 配合高频信号发生器和遥控器，完成AM接收头测试，此为测试台源程序。-With high-frequency signal generator, the first test to complete AM receiver, the source code for the test.
ExperimentalIVembeddedsystemdevelopment
- 嵌入式系统实验四—Linux 下 设备驱动程序的开发-Embedded systems under the experimental four-Linux device driver development