资源列表
LPC2132_LCM12864
- 利用微處理器LPC2132去驅動LCD 128*64-LPC2132 microprocessor to drive the use of LCD 128* 64
SP200S_V100.RAR
- 单片机编程资料，应用于AT89S52中。可在伟纳电子上下载硬件电路-Single-chip programming information used in the AT89S52. Can be downloaded Wei nanoelectronic circuit hardware
kongzhiyuyinzip
- 本人开发的利用WT-588D语音芯片做的机器人语音控制程序。使用AVR 16单片机-I developed the use of WT-588D chip to do the robot voice voice control procedures.
adc0809vhdk
- 对adc0809的控制及数码管输出，能直观的看见电压数-Of adc0809 control and digital control output voltage can see a number of intuitive
anjian
- 最基本的vhdl程序，能实现一小时的计时，且加入按键功能-Vhdl basic procedures, to achieve a one-hour time, and by adding key features
aianxiaodou
- 用vhdl语言实现对按键的消抖，消除按键的抖动对系统造成的误判-Vhdl language used to achieve the elimination of key Buffeting to eliminate jitter button on the system caused by misjudgment
61549818vote
- 希望对你们有些帮助,对于初学者很有用，可以仿真-Some of you would like to help, very useful for beginners, you can simulation
clock
- 51单片机电子时钟源码,数码管显示,经过实物验证-51 single-chip electronic clock source, digital display, after the physical verification
ATMAGE128uartasksendinterruptreceive
- 本程序经调试好使，如果程序不好使，请注意检查更改波特率和晶振频率以及检查调试助手和单片机的熔丝位设置,尤其是103兼容模式的熔丝位不编程M128和M16串口通信程序大同小异，M128有两个串口UART0、UART1而M16只有一个串口UART，只需要修改相应的寄存器和引脚设置即可中断方式接收能有效防止（采用查询方式接收）单片机外部设备不正常，不能收到数据死机-After debugging the program so that, if the process not so, please no
I2C
- 周立功的I2C总线模块驱动程序,针对ARM213X系列处理器-iic driver
8051-ds12887--
- 8051 与1602液晶，软件定时可随意调节时分秒。3个按键-8051 and 1602 LCD and software are free to adjust from time to time when minutes and seconds. 3 keys
ds1302
- 本程序代码是ds1302汇编程序，读写显示年月日-This procedure is ds1302 assembler code, reading and writing show date