资源列表
Keyboard_Scan2
- This Application Note describes programming techniques implemented on the AT91 ARM-based microcontroller for scanning a 4x4 Keyboard matrix usually found in both consumer and industrial applications for numeric data entry.
16029999
- 本系统能用液晶1602显示6位的计数器，能计算，功能一般，适合初级学者-1602 the system can be used liquid crystal display of the counter 6 to the calculation, the general function for the primary scholar
LatticeMico8_v3_0_Verilog
- The LatticeMico8™ is an 8-bit microcontroller optimized for Field Programmable Gate Arrays (FPGAs) and Crossover Programmable Logic Device architectures from Lattice. Combining a full 18-bit wide instruction set with 16 or 32 General Purpose r
upload
- This MIPS program outputs the binary equivalents of the entered decimal in the grouped & sorted order # with respect to counted 1s. Works for maximum of 32bits.
Decimal_to_binary
- This MIPS program gets an input of a decimal number and converts it to its binary equivalent.
decimaltobase
- This MIPS program converts any decimal number to its equivalent for any bases.
MIPS_Power
- This MIPS program takes a number and power and gives the result of the specified power of that number. Ex: Number = 10 Power = 2 Result = 1-This MIPS program takes a number and power and gives the result of the specified power of that number
Addition_multiplication
- This MIPS program performs addition and multiplication operations for any two input numbers with fraction, via differentiating left and right hand sides and performing the specified operation.
heappppsorttt
- This MIPS program performs a Heap Sort for a predefined workload.
yetert
- This package includes 4-bit calculator designed in Xilinx FPGA 10 using VHDL. This calculator contains 3 registers, 1 ALU, 1 decoder and 1 FSM (finite state machine).
601120ROTGL_mit_Stempeln_neuer_Oberrahmen_V40
- Software for an operating table model MOT 6000. Written in Bascom for Atmega128
601120ROTGL_mit_Stempeln_V40
- Software for operating table written in bascom