资源列表
UC-OS2
- UC-OS2 教學說明手冊-UC-OS2 教學說明手冊................
hz16
- 用于在汉字点阵字库中提取点阵信息，主要用于下位机汉字显示-Dot matrix character font used in the lattice to extract information, the main characters for the display of digital machines
TIMER
- 基于LPC2103的定时器程序。可以直接使用。ADS环境-Procedures based on the LPC2103 timer. Can be used directly. ADS Environmental
UART
- 基于LPC2103的串口程序，UART。ADS开发环境-Procedures based on the LPC2103 serial, UART. ADS development environment
shuzinaozhong
- 一个数字闹钟的vhdl代码！ 分成几个模块 要通过自顶向下的设计方法来做！-A digital clock vhdl code! Divided into several modules through top-down design method to do!
FINAL6MHz
- 51单片机智能车控制程序 供智能小车实验使用-51 single-chip smart car control procedures for the experimental use of the smart car
OLED_Driver
- OLED panel Driver for C51 STC and 25 serics flash driver
ProteusSimulationAndSourceCode
- 有关在Proteus仿真软件下的仿真文件及所使用的源代码，包括数码管键盘应用、数模转换、温度传感器DS18B20、SPI和I2C总线的应用。-Proteus simulation software in the simulation by the use of documents and source code, including the application of digital control keyboard, digital-to-analog converters, tempera
juzhenjianpan
- 矩阵健盘设计！用了MAXPLUS软件！ 矩阵健盘设计！用了MAXPLUS软件！-juzhenjianpan
Keyboad_071023
- 用89C51单片机写的一款键盘检测程序，将检测到键值通过232接口发送给主控板，主控板根据相应的要求点亮键盘上LED指示灯。-89C51 single-chip microcomputer with a keyboard to write the testing procedures, will be detected through the key 232 sent to the control board, main control board in accordance with the
LCD_KEY
- c8051f驱动LCD与KEY，用按键控制LCD显示 -LCD driver c8051f and KEY, key control with LCD display
Remoteprocedure1
- 本人用c语言编写了用tsop1738的接收程序，采用的时间中断-tsop1738