CDN加速镜像 | 设为首页 | 加入收藏夹
当前位置: 首页 源码下载 嵌入式/单片机编程

资源列表

« 1 2 ... .58 .59 .60 .61 .62 9563.64 .65 .66 .67 .68 ... 33646 »
  1. ourdev_449212

    0下载:
  2. 行业内有前辈用这款MCU的吗?希望有人能指点,我先把资料穿上来-Industry, there are predecessors of the right to use this MCU? I hope someone can point, I first put the information to
  3. 所属分类:SCM

    • 发布日期:2017-05-11
    • 文件大小:2.18mb
    • 提供者:DAYULEE
  1. C8051F330_wave

    0下载:
  2. 在C8051F330芯片上实现正弦波的程序,直接编译就可以使用。-C8051F330 chip in the sine wave of the procedures, the compiler can use directly.
  3. 所属分类:SCM

    • 发布日期:2017-04-10
    • 文件大小:1.17kb
    • 提供者:杨涛
  1. MultipleTasks

    0下载:
  2. This is te code written in ucos for firebird 5. It follows a white line and applies automatic cruise control.
  3. 所属分类:uCOS

  1. PLC1

    0下载:
  2. 几个特别好的plc代码,与大家共享。希望能对大家有帮助。-Plc a few particularly good code, and for all to share. I hope you can help.
  3. 所属分类:Embeded-SCM Develop

    • 发布日期:2017-04-02
    • 文件大小:365.4kb
    • 提供者:王辉
  1. c8051f330led

    0下载:
  2. C8051F330 led灯(汇编)程序,编译后可以直接使用,请看仔细管脚定义,如果不用请修改参数即可。-C8051F330 led lamp (compiled) program, the compiler can be used directly, see the detailed pin definitions, if you can not change the parameters.
  3. 所属分类:SCM

    • 发布日期:2017-04-08
    • 文件大小:2.79kb
    • 提供者:杨涛
  1. PLC3

    0下载:
  2. 几个有用的plc代码,希望与各位分享,对大家学习帮助。-Plc few useful code, I hope to share with you, and help them to learn.
  3. 所属分类:Other Embeded program

    • 发布日期:2017-04-05
    • 文件大小:5.91kb
    • 提供者:王辉
  1. steppermotorcontrol

    0下载:
  2. 基于AT89S52的单片机控制步进电机程序。可以实现正转、反转、正向加速、反向加速和停止功能-AT89S52 microcontroller-based stepper motor control program. Can be achieved is to switch, reverse, forward acceleration, reverse acceleration and stop function
  3. 所属分类:SCM

    • 发布日期:2017-04-11
    • 文件大小:1.09kb
    • 提供者:cheng
  1. success

    0下载:
  2. 本系统的控制模块采用STC89C51RC单片机,该单片机是针对控制优化设计的,适用于低功耗、高集成度和高性能要求的控制应用场合,并且能够在线进行程序的烧写。单片机实现对整个系统的控制,主要实现对无线终端报警系统的控制-The control module of the system using single-chip STC89C51RC, the single chip is optimized for control design, applicable to low-power, high
  3. 所属分类:SCM

    • 发布日期:2017-04-02
    • 文件大小:28.27kb
    • 提供者:何健飞
  1. 12864LCD

    0下载:
  2. 用液晶模块的做一个菜单的程序,并附带有仿真图能用联调。-LCD module with a menu of procedures, together with simulation of plan can be used with the FBI.
  3. 所属分类:SCM

    • 发布日期:2017-04-17
    • 文件大小:111.66kb
    • 提供者:何健飞
  1. source_code

    0下载:
  2. 该方案采用TI_MSP430FG439单片机为核心,心电信号经FG439内部三个运放放大以及FG439内部的12位A/D转换然后通过LCD 显示每分钟的心率和通过PC显示心电图-TI_MSP430FG439 single chip using the program as the core, an internal ECG by three FG439 and FG439 enlarge OPAMP within 12 A/D converter and then through the LCD
  3. 所属分类:SCM

    • 发布日期:2017-03-29
    • 文件大小:35.43kb
    • 提供者:何健飞
  1. lcd1

    0下载:
  2. 一个使用液晶模块的程序,通过自定义串口传输控制命令和数据信号-A procedure for the use of LCD modules through a custom serial control commands and data transmission signals
  3. 所属分类:SCM

    • 发布日期:2017-04-16
    • 文件大小:21.34kb
    • 提供者:何健飞
  1. ADC_FOR_EASYARM1138

    0下载:
  2. easyarm1138上ADC采样程序,通过处理器直接触发ADC采样,ADC模拟量需从外部输入(ADC0),最大不能超过3.0V,因为ADC内置的参考电压为3.0V-easyarm1138 on the ADC sampling procedures, directly through the processor to trigger ADC sampling, ADC analog input from the external (ADC0), the largest not more tha
  3. 所属分类:Embeded-SCM Develop

    • 发布日期:2017-04-04
    • 文件大小:18.68kb
    • 提供者:
« 1 2 ... .58 .59 .60 .61 .62 9563.64 .65 .66 .67 .68 ... 33646 »
搜珍网 www.dssz.com