资源列表
dingshiqi
- 利用单片机内置的定时器实现定时时间到后产生中断功能-The use of single-chip built-in timer to achieve timing
dianzizhong
- 利用单片机实现模拟电子时钟在数码管上显示分秒-The use of single-chip analog clock in the digital electronic control display minutes and seconds
51display
- 51系列单片机在LCM上的显示程序，应该有广泛的借鉴意义-51 Series single-chip display in the LCM procedure, there should be a wide range of reference
v311_5408AD
- STC12C5408AD单片机通过SPI接口实现对语音芯片ISD1700的操控。该源码为实验程序，供参考。-Single-chip STC12C5408AD through the SPI interface to control the ISD1700 voice chip. The source for the experimental procedure, for reference.
msp430x54x_flashwrite_04
- MSP430x54x Flash读写代码-MSP430x54x Flash write sample code
RTC_Workaround
- MSP430x54x 实时时钟示例代码-MSP430x54x RTC sample code
kuozhancunchu
- 设计一个程序，向62256的0000H～0013H存储单元里依次连续 写 入数据1到20。接着依次再从这些单元中读出这20个数，并求这20个数的累加和（结果应为D2H），将其通过P1口送出（仿真电路中的发光二极管D1～D8）。-Design a program to 62,256 of the 0000H ~ 0013H memory cell in order to write the data for 1-20. Followed by a further unit from the rea
waibuzhongduan
- 采用外部中断INT0（用按键BUTTON模拟）中断，单片机P2口为输出口外接两位LED数码管。每申请一次中断（按下BUTTON），在中断处理程序中对数码管的显示数据作加1改变（实验中P2口外接的两位LED数码管采用7447硬件译码的方式以BCD码显示）。-The use of external interrupt INT0 (with simulated BUTTON button) interrupt, microcontroller P2 output port for an externa
infrared_remote_control_information
- 单片机红外遥控综合资料，包含各类电视遥控协议，C语言和汇编语言解码范例程序-Comprehensive information on single-chip infrared remote control, including all kinds of TV remote control protocol, C language and assembly language sample program decoder
Soure
- finger print interface 8051
BH1415
- BH1415调频发射芯片的89S52汇编控制及LED显示控制代码-BH1415 FM transmitter compilation 89S52 chip control and LED display control code
T
- 一个线性光耦测试仪的Protel图，原理很简单； 电阻的阻值，在12V下，1K就可以，变阻器的阻值1K-3K均可-A linear optocoupler tester Protel map, the principle is very simple resistance value, in the 12V under, 1K can, rheostat resistance of 1K-3K may be