资源列表
newjs
- 允许CPU中断,定时器0中断打开 ,设定时器0为模式1，16位模式设定时值为20000us.-allow the cpu to interrupt ,set the timer to mode 1,set the timing to 20000us.
MAX038
- 基于单片机的智能信号发生器的设计，单片机AT89C52，集成芯片MAX038.--MCU-based design of intelligent signal generator, microcontroller AT89C52, chip MAX038 .-
8WMB
- 8位数码管秒表计时显示,初始状态8位数码管显示0000000 按按键，计时开始 再按一次 计数停止 按第三次 计数值清零 -8 bit of LED to display the status of timer
1602jm
- 本程序主要是遥控器解码和1602驱动程序，主要功能是解码红外线遥控器。遥控器芯片:tc9012-0-This program is used to decode the infrared remote controler.
USB
- CEPARKUSB学习板之实战第一个USB程序USB键盘-Study of actual board CEPARKUSB the first USB keyboard USB program
USkBeyboard
- c.CEPARKUSB学习板之实战第一个USB程序USB键盘-study of actual board c.CEPARKUSB the first USB keyboard USB program
Usbdisk
- g.CEPark USB学习板之实战第五个USB程序：假U盘-Learning g.CEPark USB board USB fifth of the actual procedures: sham U disk
edk_hc164
- 瑞芯科技EFX400SL开发板使用ISE创建的HC164的工程源码-Rockchip EFX400SL technology development board created by the use of ISE source project HC164
CurrentSense
- 内含仿真图，可以根据实际情况迳行调试，很好实用的-The simulation includes maps, according to the actual situation may be different debugging line, a good practical
sdcard_spi
- 自己翻译的SD卡规范协议，SPI模式的，马马虎虎了。-Own translation of SD card specification agreement, SPI mode, a so-so.
0809-MCU-51
- 采用51单片机和0809组合，可以做成可调电压，方便使用，有数码管就比较直观，相当一个定电源，很不错的。-And 0809 using 51 single-chip portfolio, you can make an adjustable voltage, user-friendly, digital control is more intuitive, rather a fixed power supply, very good.
counter
- 使用51和数码管做的一个计数器，虽然网上很多，但不能满足实际应用，我做的这个已经使用了一段时间，很稳定，你要是想移植到其他程序里，也可以使用（内含仿真图，）-The use of 51 and digital control to do a counter, even though many online, but you can not meet the practical application, I do have to use this for some time, it is stab