资源列表
capt
- 基于K60的图像采集程序，完整，实测可行，基于0v7620-K60-based image acquisition program, complete, actual feasible, based 0v7620
MSP430
- 采用MSP430单片机对步进电机的控制，通过I/O口输出的时序方波作为步进电机的控制信号，信号经过芯片ULN2003驱动步进电机；同时，用 4个按键来对电机的状态进行控制，并用数码管动态显示电机的转速。-Using MSP430 microcontroller stepper motor control, through the I/O port output timing square wave as stepper motor control signals, the signal afte
cc2500
- CC2500驱动程序，基于51单片机的编程-CC2500 driver, based on 51 microcontroller programming
12864
- 这是液晶显示屏JPG12864的原理图和驱动代码，开发环境为IAR-This is the LCD screen JPG12864 schematic and driver code, development environment for IAR
CC430
- 基于CC430单片机的无线传感器网络节点驱动程序-CC430 microcontroller-based wireless sensor network node drivers
simpliciTI---2
- SimpliciTI协议内容及全部源程序-SimpliciTI agreement and all of the source code
RF_Example_Code
- CC430单片机的无线对发数据，用于两节点之间的通信-CC430 microcontroller wireless data on the hair for communication between two nodes
stm32_controller
- 基于STM32的工业控制器电路图.wps,希望大家喜欢-STM32-based industrial controller circuit. Wps
NXP_M3_DSPLib
- NXP 元件库 ， 路虎开发板LPC1768-NXP library, Land Rover LPC1768 development board
main
- 基于LPC2131的两路PWM，三段式调速，12864显示：档位、方向显示-Based on LPC2131 two PWM, three-speed, 12,864 Show: stalls, direction display
C8051FXX-boot-loader-
- 主要描述了C8051F0XX系列单片机的引导装入程序考虑及举例-Mainly described C8051F0XX Series MCU boot loader and examples be considered
Configure-port-IO-Crossbar-Decoder
- C8051F0xx系列单片机如何配置端口IO交叉开关译码器-How to configure port C8051F0xx MCU IO Crossbar Decoder