资源列表
S1
- 程序功能：用DS18B20测量室温并在数码管上显示。测试说明：观察显示温度数值。-Program Function: DS18B20 temperature measurement and digital display. Test Descr iption: To observe the display temperature values.
AD2
- 程序功能：MCU的片内ADC对P6.0端口的电压进行转换将模拟电压值显示在1602液晶上。-Program features: MCU on-chip ADC for converting the voltage P6.0 port analog voltage value is displayed on the LCD 1602.
C3
- 程序功能：在1602液晶上显示用MCU的TimerA模拟的数字式实时时钟。-Program features: LCD display with 1602 MCU' s TimerA analog digital real-time clock.
ICR
- 红外线通信控制，使用配套的NEC遥控器，按下电源按键，继电器动作 -Infrared communication controller
LCD
- LCD显示驱动，使用8位并行接口,可以显示图形和字符-LCD display controller
8X8dianzhen
- 8X8点阵，实现了0到9的循环显示。适合初学者了解点阵扫描和取模的概念-8X8 matrix, to achieve the 0-9 loop display. Dot matrix scanning and suitable for beginners to understand the concept of modulo
Music-LZ
- 音乐播放－梁山伯与祝英台。单片机用T0中断在IO口P1.5输出乐曲-The output of music
Timer
- 定时器中断 24小时时钟程序，采用数码管-The timer interrupt
28BYJ48-5Vstepper-motor-speed
- 28BYJ48-5V电机调速程序，适合初学者，基于STC89C52，很典型-28BYJ48-5V motor speed control procedures, suitable for beginners, based on STC89C52, a typical
Ultrasonic-Ranging
- 利用超声波测距模块_HC-SR04进行超声波测距后，将测得的距离显示到128*64的LCD上，并附有HC-SR04用户手册。-Using ultrasonic ranging module _HC-SR04 ultrasonic distance measurement, it will display the measured distance to 128* 64 LCD, along with HC-SR04 user manual.
readFLASH-writeLCD
- 单片机利用SPI总线从flash读取图像数据并通过SPI写入液晶屏。-Microcontroller using SPI bus to read image data from the flash and write into the LCD screen via the SPI interface.
JIAOTONGDENG
- 交通灯底部开发程序,程序是通过P1口输出-Traffic lights at the bottom of the development process