资源列表
use-flash-to-store-calibration-data
- 基于stm32固件库的flash驱动，可以将断电需要保存的数据存储在flash中。-It s a driver of flash option based on STM32 firmware, you can save power required data is stored in flash memory.
read18b20rom
- 18b20是单总线数字温度传感器，可以在一根总线上挂接多个18b20，这里就需要发匹配ROM命令，需要传感器的64位ROM,本程序可以读出64的数据，在电脑里用串口助手显示出，为多18b20操作做好准备。-18b20 is a single-bus digital temperature sensor can be mounted on the bus in a multiple 18b20, where you need to send Match ROM command, you need
74HC595Drive
- 单片机控制74HC595驱动程序，数码管动态扫描显示，支持浮点数操作。-SCM control 74HC595 driver, digital dynamic scan showed support for floating point operations.
CAdvanced_FUJISHITU
- FUJISHITU 16位单片机C语言手册，编程说明及指导。-FUJISHITU 16-bit microcontroller C language manuals, programming instructions and guidance.
MB90340
- 富士通新8位单片机MB90340 示例程序，包含各个子涵，开发时刻直接调用或修改。-Fujitsu 8-bit microcontroller MB90340 new sample program, including various sub-Han, development time called directly or modified.
schPasm
- 基于AT89C51+MAX7219的频率计 附带proteus仿真电路图 实际硬件电路测试通过-FREQ design Base on AT89C51+MAX7219,include sim DSN and hardware SCH
TIMER
- 51单片机自制的秒表计时器实验，采用内部定时器，可以按键调节，清零，启动，注意自己更改IO设置！-51 single homemade stopwatch timer experiments using internal timer, you can adjust buttons, clear, start, pay attention to their changing IO settings!
msp430Flash-read-and-write
- msp430f149单片机flash数据读写程序-MSP430F149 singlechip FLASH read and write data program
computer-write-data-to-mcu
- 电脑写入数据到msp430f149单片机的flash中-The computer is writing data to the msp430 microcontroller
BMP085-STC12
- BMP805大气压传感器--基于STC12C5A32S2单片机测试成功的C程序-BMP805 pressure sensor- based SCM test STC12C5A32S2 C program success
keyscan_state
- 基于51单片机实现4x4矩阵键盘，按键消抖的状态机。-Based on 51 MCU 4x4 matrix keyboard, key debounce state machine.
chuankoucewen
- 可以显示负温度 数码管显示同时通过串口发送到电脑端显示 使用dofly配套的测温软件 晶振使用11.0592M-Can show a negative temperature Digital display simultaneously sent to the PC via the serial display