资源列表
PCB
- 这是code使用说明,对大家比较有帮助，新手必备-This is the code for use
DS18B20(LCD)2
- 基于富士通单片机的ds18b20的c程序-Based on Fujitsu MCU ds18b20 c program
c_menu
- 一个C语言的菜单实例,可以直接运行,可参考写出更详细的代码。-Examples of a C-language menu, you can run directly refer to write a more detailed code.
ds18b20
- 采用单总线的温度传感器DS18B20,测量温度精度高。-Single-bus temperature sensor DS18B20, measure the temperature with high accuracy.
UART_avr
- 使用AVR单片机，主机芯片为ATMEGA16L,程序为多机通讯用。-Use AVR host chip ATMEGA16L, procedures for the multi-machine communication with.
uart_rec_send
- 串口中断服务程序，仅需做简单调用即可完成串口输入输出的处理,出入均设有缓冲区，大小可任意设置 芯 片:AMEGA16-Serial interrupt service routine, just make a simple call to the completion of serial input and output, have access to the buffer size can be set chip: AMEGA16
1123sdfs
- 单片机初学者资料 51单片机C语言编程入门(详讲版)-Singlechip beginners
dht11
- DHT11的驱动程序只是简单的读出数据,使用的是430f149-DHT11 drivers simply read
1
- 1602 液晶 时钟程序 c8051单片机程序-1602 LCD clock program c8051 microcontroller program
code1
- 采用单片机及其外围电路设计的多功能信号发生器。它采用编程的方法来产生方波、锯齿波、三角波、正弦波。-SCM and its peripheral circuit design using multifunctional signal generator. It uses programming methods to produce a square wave, sawtooth, triangle wave, sine wave.
MSP430SPI
- MSP430通用的spi驱动数码管的程序，需要结合74hc595使用-MSP430 generic spi-driven digital control of the program, you need to use a combination 74hc595
MSP430shi_li
- 一些在工程设计中需要用的实际例程如串口通信，spi,IIC等并且带有电路图哦-Some of the need to use in engineering design practice routines as a serial port communication, spi, IIC, etc with circuit diagram