资源列表
ISD4002-120
- ISD4002-120语音录放芯片51单片机C语言驱动程序，头文件，使用时调用即可，有详细注释-ISD4002-120 voice recorder chip microcontroller C language driver 51, header files, you can call using the detailed notes
CCD_Acquisition
- 基于freescale MC9S12dg128 MCU的CCD采集程序-Based freescale MC9S12dg128 MCU CCD Acquisition Program
GPS1000U
- GPS-1000U模块单片机驱动程序，内有12864液晶显示程序，实时显示北京时间、经纬度、海拔等信息，-GPS-1000U module microcontroller drivers, there are 12,864 LCD procedures, real-time display GMT, latitude, longitude, altitude and other information,
PT4_capture(PT4)
- 基于freescale MC9S12DG128 MCU的捕获程序-Based freescale MC9S12DG128 MCU capture program
auto_cayanji
- 全自动炒茶机源程序，电路图，电路板。仅供参考，或仅限于非商业目的，否则后果自负。-Automatic Tea Maker fried source, schematics, circuit boards. For reference, or limited to non-commercial purposes, or peril.
ADC
- 基于STM32F107MCU的ADC模块- The ADC module based STM32F107MCU
bilu_cont
- 壁炉控制器的程序，用PIC芯做的，用继电器控制加热丝，灯光，风机。-Fireplace controller procedures done with PIC core, with relay control heating wire, lights, fans.
1.LED-LIGHT
- 点亮p0口led 运用左移与右移指令进行编写，stc单片机-Light p0 port led to write using the left and the right instructions, on STC microcontroller
2.Button-handler
- 四个按键，SL13到SL16为4个独立按键 按下SL13-SL16时，对应的LEDE1-LEDE4灯亮。-Four key, SL13 to SL16 as four separate buttons Press the SL13- SL16, corresponding LEDE1- LEDE4 lights.
3.AD-out
- 本程序使用了串口1进行AD数值输出。-This procedure using the serial port 1 AD numerical output. If need to change the channel of the test, please change the value of ch.
4.1602
- 1602液晶的编写程序，使用stc单片机，编写欢迎界面-1602 LCD programming, use on STC microcontroller, write the welcome screen
5.Matrix-key
- 矩阵按键测试程序, 输出结果用串口传输到上位机显示-Matrix key test program, the output with serial transmission to the PC