资源列表
PD
- _Where The position in the target deque where the first element is inserted. _Val The value of the element being inserted into the deque. _Count
TCPIPprotocolOnuCOS-II
- 在uC/OS-II嵌入式操作系统中的TCP/IP协议实现，在ADS1.2中操作-In uC/OS-II embedded in the operating system TCP/IP protocol implementation, to operate in the ADS1.2
USB_ARM_2410
- 在三星ARM9芯片S32410实现USB数据通信，源码包含了USB的驱动程序-Samsung ARM9 chip S32410 achieve USB data communication, source code contains the USB drivers
AT91_TCPIP
- 基于ARM9芯片AT91，uC/OS-II操作系统下的TCP/IP上层协议实现-Based on the ARM9 chip, AT91, uC/OS-II operating system' s TCP/IP protocol implementation upper
uart_ucos
- 使用三星ARM9芯片S3C2410A，在uC/OS-II操作系统中实现串口的配置和数据传输-The use of Samsung ARM9 chips S3C2410A, in the uC/OS-II operating system to implement serial port configuration and data transfer
yuyuanyetest
- 在8051f340下ucos的移植drv文件夹下是我的硬件驱动，可以不必理会-ucos for 8051 f340
LPC2368KitV0.2
- lpc2368下移植ucosii，实现uart0，uart1，uart2各个接口通信。缓冲区采用队列实现接收发送。-lpc2368 transplanted under ucosii, to achieve uart0, uart1, uart2 each interface communication. Achieved using a queue to receive a buffer to send.
ucos_2812
- 在CCS2.21下的，将UCOS-II移植到TMS320F2812上的实例，2812外频20M主频100M,可作为UCOS移植入门实例-Under the CCS2.21 will UCOS-II ported to an instance on the TMS320F2812, 2812 FSB 20M GHz 100M, can be used as examples of UCOS portable entry
uCOS-II-CN
- 本书详细介绍了ucos嵌入式操作系统的内部运行原理以及相应函数的定义说明及应用！对在嵌入式系统上构建ucos以及应用都有很大的帮助-This book details the ucos embedded operating system' s internal operation principle and the corresponding definition of the function and application instructions! In the embedded s
arm_ucos_zhankongbi
- 使用PWM6输出PWM信号,由KEY1控制PWM占空比,每按一次,按键将会改变一次PWM的占空比.（采用UCOS操作系统编程。）-Use PWM6 output PWM signal, KEY1 controlled by the PWM duty cycle, every time, a button will change the PWM duty cycle. (Using UCOS operating system programming.)
UCOSII
- 基于三星2410UCOSII的几个演示程序-Samsung 2410UCOSII based on a few demo program
AN9256
- ucos 在at91sam7x256上的 官方移植范例 绝对经典-uc/os on at91sam7x256,