资源列表
complex_pump_0_02
- 介绍如何用较复杂的方法去优化对负载具有感知特性的“黑匣子”模型的神经网络控制。-Shows how to use the complex method to optimize a black-box neural network model of a load-sensing
array
- 用汇编语言在VISUALDSP++4.0实现的矩阵相乘代码-Using assembly language at VISUALDSP++4.0 code implementation of matrix multiply
NoiseCancelationbf537
- noise cancelation useing DSP BF537
LCD
- DSP显示器点亮程序，比较经典，不知道这边有没用，先上传再说-DSP display lit procedures, compare the classic, I do not know there is no use here, first upload again
MODbus
- MODBUS代码，希望对各位有所帮助，相互传阅，才能有进步-MODBUS code you want to help each other circulated in order to have progress
xds560_troubleshooting
- xds560 的简单介绍 可以接dm6446-hao
F2812_Flash
- TI CMD用于FLASH的可以使用的文件-TI CMD can be used for the FLASH of the document
DEC6713_BOOT
- SEED-DEC6713共可实现2种Boot方式，分别为EMIF引导和HPI 引导。这里是通过EMIF扩展的FLASH引导的测试程序。-SEED-DEC6713 achieve a total of two kinds of Boot mode, respectively EMIF and HPI guide to guide. Here are the FLASH through the EMIF boot to expand the test procedure.
DEC6713_EEPROM
- DEC6713的EEPROM测试程序。主要包括EEPROM的读写操作。-DEC6713 the EEPROM test procedure. Including reading and writing EEPROM operation.
DEC6713_GPIO
- DEC6713板卡上通过GPIO来点亮、熄灭LED的测试程序。-DEC6713 board to light up through the GPIO, LED out of the test procedure.
DEC6713_UART
- 录DEC6713的UART串口的测试程序。需要将板上的跳针JP3、JP5各自短接，将UART通道A 和通道B均配置为RS232方式。-Recorded in the UART serial DEC6713 test procedures. Need to jump on-board pin of JP3, JP5 their shorted to UART channel A and channel B are configured for RS232 mode.
DEC6713_USB
- 主要测试USB 连接并通过USB 接口控制SEED-DEC6713 上各种资源进行工作。由CY7C68001 兼容USB1.1 与USB2.0 标准，所以在一般的计算机上均能 进行USB 的调试。-USB to connect the main test and control through the USB interface on a variety of SEED-DEC6713 job resources. By USB1.1 and USB2.0 compatible CY7C68