资源列表
pic10f222
- 单片机做的门铃程序，已调试通过，可正常使用-The program to do, has been debugged, can use normally
HYG1926445C-FF62L-VB
- 此为华远显示128*64 LCD驱动程序，该程序也适用于带NT7108C控制器的LCD-This is the Huayuan 128* 64 LCD display driver, the program also applies to LCD controller with NT7108C
code-for-interfacing-24C04-I2C-EEPROM-with-8051.r
- EPROM INTERFACE WITH 8051
signal-generator-v1.0
- 基于C8051F020单片机的信号发生器设计，实现的功能输出波形：正弦波，方波，三角波，频率100Hz~10KHz（未使用DDS设计）-Based on C8051F020 MCU signal generator design, functions output waveforms: sine, square, triangle wave, frequency 100Hz ~ 10KHz (unused DDS design)
CSR_BT_atenna_design_guide
- CSR蓝牙芯片的天线设计指导文档，主要为PIF天线和蛇形PCB天线。-CSR Bluetooth chip antenna design guidance documents, mainly for PIF antenna and serpentine PCB antenna.
CSR1010-QFN-Data-Sheet-CS-231985-DS
- CSR1010芯片手册，CSR1010为蓝牙4.0芯片，可用于很多嵌入式开发设备中。-CSR1010 chip manual, CSR1010 as Bluetooth 4.0 chip, can be used in many embedded development device.
AP-900M
- AP-900M 设计说明书，设计说明书 分享
fadingLedWithPod
- A simple C file that fades in and out an LED attached to Arduino UNO with the use of a potensiometer. The code is C. The potentiometer has to be attached to analog pin 0 and the LED to digital pin 6. It uses both ADC ( analog to digital conversi
wirelesslight
- zigbee技术无线点控制台灯，学习zigbee技术的实验例程-zigbee wireless point control lamp technology, learning zigbee technology test routines
ourdev_602129SHV7T2
- RJ45 PACKAGE.YOU CAN USE IT FREELY.-RJ45 PACKAGE.
TimeBeep_C
- 使用定时器0实现1秒定时,控制蜂鸣器蜂鸣-The use of timer 0 to achieve a second time, control buzzer
基于mega8l的交通灯仿真及程序
- 基于mega8l的简易交通灯仿真 数码管实时显示 以及mega8l的编程源程序