资源列表
STM32-USART_RFM12B_2
- transimision data using the module rfm12b and visualized by using microcontroller USART STM32F103
ProgramCANandMOTER
- 单片机控制CAN Bus的通信，进而实现控制发动机，这个控制过程是开环的。-The micro-controler controls the communiaction of CAN Bus, and thus realize the control moter. The control process is open loop.
spimaster
- SD卡读写源代码.用Verilog编写.很不错.值得借鉴.特别对SD卡开发的人员!--SD card reader-writer source code. Prepared to use Verilog. Is pretty good. Be used for reference. In particular, the development of personnel SD card!
nuc123PWAU8822
- NUC123驱动WAU8822，音频数据用I2S格式-NUC123 drive WAU8822, audio data with I2S format
Measurement-amplifier
- 程控增益测量放大器源码，按键实现1024倍信号放大，步进为1，增益显示在LCD1602上-Programmable gain instrumentation amplifier source, the buttons for the 1024-fold signal amplification step of 1, a gain on the LCD1602 display
nuc123_ps2
- nuc123系列芯片ps2驱动样例完整程序-Nuc123 ps2 driver sample complete program
liushuideng
- 用msp430实现流水灯点亮，包括正向亮和反向亮两种。-With msp430 achieve water lights, including forward and reverse lights bright two kinds.
T1
- 用定时器T1的查询方式控制51单片机发出1KHz音频-Timer T1 controls the microcontroller 51 queries issued 1KHz Audio
GPS and sending sms to gsm
- this project gps and gsm using for tracking application
liushuideng
- 采用51单片机，分别用延迟法和定时器法实现流水灯的8位循环。-Using 51 microcontroller, respectively, to achieve law and delay timer law of eight light water cycle.
beeh204dev
- norflash derver,testing now
IARAD
- 可以对传感器的模拟输出信号进行采集，通过转换为数据信号然后传给单片机做处理-Can simulate the output signal of the sensor acquisition, by converting the data signal to the microcontroller then do processing