资源列表
music
- 单片机产生音乐源码及上频谱转码工具。 单片机通过控制引脚的高低电平来产生频率，接着再控制输出频率时间就可产生美妙的音乐。-SCM source code and produce music spectrum transcoding tool. Microcontroller to generate a frequency by controlling the pin high and low, and then again to control the output frequency
test1
- 编写Main主程序，循环调用子程LED_Display，动态点亮4位数码管，使得数码管的显示为“0123”。-Write Main main program, a subroutine call cycle LED_Display, dynamic light four digital tube, making the digital display as " 0123.
step
- 用8051端口控制步进电机，编写程序输出脉冲序列到8051端口，控制步进电机正转，反转，加速，减速。-8051 port stepper motor control, programming of the output pulse sequence to the 8051 port, stepper motor control forward, reverse, speed up, slow down.
jiantongdeng
- 基于51单片机的交通灯设计，可以进行十字路口的交通管制，并有蜂鸣器报警。-51 microcontroller-based design of traffic lights, traffic control can be a crossroads, and a buzzer alarm.
430
- msp430f149三相逆变电源源代码，可以输出6路spwm信号-msp430f149 spwm
ADC
- PIC ad采样并在数码管上显示，精度不高 但是方法可以借鉴的。-PIC ad samples and displays, accuracy is not high but the method can draw.
TM1618A
- TM1618数码管驱动芯片程序，在51单片机测试通过-TM1618SHUMAGUAN QUDONG IC PRO,ZAI 51 MCU CESHI TONGGUO
1
- 使用AD623放大后的电压信号采集，模数转换是LTC1865，可两通道同时采样。-Voltage signal acquisition using AD623 amplified, analog-to-digital conversion is LTC1865, the two channels can be sampled simultaneously.
w25q128_flash
- 文帮FLASH-W25Q128最精炼的读写程序，有FAT接口。实用于STM32F20XXX！也可用于其它系列！-Man helping FLASH-W25Q128 most refined literacy program, there are FAT interface. Practical in STM32F20XXX! Can also be used for other series!
2011-1-26---100
- 使用89C51和MAX1898设计的智能充电器，有PROTEUS仿真和源码。-Use 89C51 MAX1898 design and smart charger with PROTEUS simulation and source code.
SEG_DYNA
- 普中HC6800V30的Proteus仿真程序-Proteus examples for Puzhong HC6800V30(动态显示)
stm32-cc3000
- stm32作为host驱动德州仪器的CC3000 wifi模块-TI s CC3000 MOD drived by stm32 as HC