资源列表
TA_JTAG_WIGGLE
- S3C2410 JTAG & WIGGLE，protel DXP原理图，带封装库-S3C2410 JTAG & WIGGLE, protel DXP schematic diagram, with package library
1
- ARM7各个功能模块的实例，并且用ADS编写相应的功能实现-ARM7 examples of the various functional modules, and used to prepare the corresponding function realization ADS
2
- ARM7各个功能模块的实例，并且用ADS编写相应的功能实现，以及ARM的具体应用-ARM7 examples of the various functional modules, and to use ADS to prepare the corresponding function realization, as well as the concrete application of ARM
stc90c58
- 一段基于STC90C58单片机的程序，keil工程，使用了P4口，中断，从串口返回数据给主机。已在某项目中成功使用。-A software of STC90C58,use serial,interrupt,P4.Has been successfully used in a project.
lpc2138
- 基于lpc2138的源程序，ADS1.2工程，使用了中断技术，通过串口返回数据。已在某项目中成功使用。-Lpc2138-based source code, ADS1.2 project, using the interrupt technique, through the serial data is returned. Has been successfully used in a project.
Buzzer
- A demo program for AT89S52-gLCD-STK1 board with 3.3V regulator & 89C51RB2-IM mcu * to blink an LED at ~10Hz by software delay * && using timer 2 to generate a single tone by the Buzzer connected to Pin P1.0. * Timing is done by softwa
blink_LED
- led blink program which is based on 89c51rd2.
ARM_Procedure_Call_Standard
- ARM procedure call standard
tst_sw
- 测试switch部分代码 在nios IDE 7.2 下调试通过-PIO part of the test code to debug through the nios IDE 7.2
tst_lcd
- 测试字符型LCD 和 SDRAM的代码 在altera IDE 7.2 下测试通过-Test character LCD and SDRAM' s code under test altera IDE 7.2
tst_it
- Altera 测试 Interval Timer 的源码 在NIOS IDE下 调试通过-Altera Test Interval Timer source code to debug through the NIOS IDE
redo_pio_irq
- 测试NIOS PIO 与 及其中断的源代码 在NIOS IDE 7.2 下调试通过-Test NIOS PIO and its interrupt source code to debug through the NIOS IDE 7.2